Board FSP048-3PI01 Where can I buy this board ? FSP048-3PI01 / BN44-00082A ? You know ?

you need every number on that tv,including numbers off the board,if you dont have it,junk the tv

Hi Christopher, where are you located? I have the same TV and am looking for the base stand and original remote if you decide to part it out.

THe CRATE board is not available anymore. This is the DSP effects board for GTX, RFX, and Taxi amps. If you can find an old one of these units, they are interchangeable directly.

Power supply board is dead.Replaced the power supply board by buy a whole refurbish power supply board for the replacement.Tries Websites like Shopjimmy.com,or Ebay,com to buy a refurbish power supply board.If u know basic electronic and soldering.Searches all around the power supply board and it supporting boards.Replaced those bad capacitors,they useally have leakage gases,they bulges up on it top,or puff up on it top.U will get ur power back and stable again.

Must buy ur version of ur board because the power supply it work with that version.

The board you need to replace is the power supply board. The board# is BA71F0F01042. Your power supply board should have the same number on the lower right side of this board.
The problem is the 6 Transformer Inverters that power up the LCD screen. If one blows out, the TV will go into protection mode like it's doing now. All the Funai TVs are having the same problem. Because, it uses the same parts.
The board is hard to find right now. Only three places I know of to find it.
Ebay,
Discount-Merchant.com,
and Shopjimmy.com
Sadly, nobody has them in stock.
I wish I had a extra board to sell you, because I know how to repair it. I have the schematics diagrams and part# for the pieces on the board.
If you ever come across a replacement board, let me know. I would like to buy your old board. Here's my e-mail, [email protected]

Part Store is good place to buy required board of KV-40XBR700

If you feel difficulty in board purchase, let me know to help you more.

Really Did not find a solution because we already know the problem. i.e the mani/digital board. BenQ will not sell us the part. We are still looking for a supplier.

NEVER NEVER Buy BenQ

No need to buy a PC board. Have professional tech solder leads back and tighten connector

Fiend your solution direct from intel. Here is your solution........



http://www.intel.com/motherboard/prob676ijt65/solution
90