No heat after 2 mins - Bosch Axxis WTL 5410 Electric Dryer

if when first comes on see if voltage to fan motor if yes bad motor if no voltage bad control board

it almost sounds like the temperature sensor is in the wrong place. that or the flow is inadequate for the heater to run. if you have a sand filter, put it on 'whirlpool' or 'recirculate' and try to run the heater.

What is the model number of the new thermostat? What could be happening is that the cycle rate needs to be changed or if it has a heat anticipator it may need to be adjusted.

5 fuel pumps and 2 motors? id say that whoever is diagnosing your car needs to be fired. toggle switches, over heating, stalling after 30 mins, new motors....you need to get this to a shop. no way someone can diag this cars serious problems and over internet.

I’m happy to assist further over the phone at https://www.6ya.com/expert/josh_8f8ad0a8f7e0e6d3

Message is displayed and sterilization does not start if the autoclave has not reached sterilization temp. after heating for 50 mins. while in wrapped or unwrapped programs (80 mins in the Glassware program).

1) Clogged air jet, clean air jet.

2) no pwer to the heating elements.

3) Low line voltage delaying heat up. Not enough power to supply unit.

It should run until it reaches the temp. setting on the thermostat.
Do you have a make and model number so I can assist you?

There should be a thermostat by the heating element you may need to have it changed...

look for the temperature sensor inside the oven cavity in the upper left or top center of the upper oven cavity,its will be a silver or copper colored rod about 1/4" by 2" to 6" long this rod senses the oven temp and cycles the heat to the oven

Hi


Thanks for using FixYa. If the clean light flashes, pauses, and then repeats. When the dishwasher doesn't sense a water temperature increase, it stops working and locks the functions (clean light flashes, all buttons are non responsive). It does this as a safety in case the element is broken and feeding electrical current into the water.

To resolve this you will have to reset the console. Do this by closing the door and press these buttons in sequence...

-high temp wash
-heated dry
-high temp wash
-heated dry



Please do rate the solution if the issue is resolved or post a comment for further assistance.


Thanks
Rylee

TURN THERMOSTAT SWITCH TO AUTO AND THEN TURN THE
OTHER SWITCH TO HEAT OR COOL. IF IT DOESN'T CUT ON AND OFF PROPERLY NOW, REPLACE THE THERMOSTAT OR MAKE SURE ALL WIRES ARE CONNECTED TO THE PROPER TERMINALS , AND IF THEY ARE THEN REPLACE THE THERMOSTAT AS SUGGESTED. REMEMBER...PUSH SETTING
TO HEAT AND WAIT 2 TO 3 MIN. TO SEE IF THE HEAT WORKS. NOW DO THE SAME FOR THE COOL AND WAIT 2 TO 3 MIN.