I have a Mcculloch MCS2001 Electric Chipper/Shredder. I need to replace the V-Cutter and the Cutter(Blade). Any idea where I should go to get these?

there's a website that has all this informationthere are many actually but I personally like few .. let me know if u need help
thanks

I take help from online websites that have this service like helping in repair some have instant help.. others are a bit slow which I don't prefer... rest is up to us.. U can also get free manuals

hello
u will find a lot of wiring diagrams and circuit diagrams and stuff like this at few sites I know
the girl in the chat box can help u instantly

Overload protection is a euphemism for too much electricity going into the motor. That can only be caused by two things - 1 - the motor is not turning freely because of some restriction in the drive mechanism or 2 - some of the motor windings have shorted out and now the motor windings have less resistance than before and more electricity is entering and less back emf is being generated.

Condition 1 is repairable 2 - fogetit - motor is shot.

Hi there's this website something like reliable-store and it is very amazing for manual for repairing servicing anything
someone on fixya recommended it to me and I thank him even today
They have full manuals and it's verrrrry cheap and mine
I got free in offers
3rd time I also had an issue with the file so the girl replaced it in 30 mins
there is one more but i don't remember its name it was 2 years back bitman something link this
Try it out brother

Some fixya user told me a website reliablestore it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try
most shredder owners know aboutt it

it's free so no harm in trying

I take
help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U get free manuals

some fixya user told me a website reliablestore
it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try

I just did one!
There are two opposing threaded holes next to the shaft.
Screw in bolts and use a wheel or gear puller to remove.
You can use a socket that fits in the center bore for an extention of your gear puller.
auttozone or ayto supply rents for free w/deposit

Reset must not lock and will be a little loose.

Check list.

Is there power to the motor??

Any damage to motor??

If no to the above get an electrician to test.