Water won't come out of the machine. It worked the night before last...I did not change any settings or touch anything. What can I check?

There are several online appliance parts stores. They are usually quite helpful in diagnosing problems and know the part giving the problem. Otherwise, a lightly used replacement may be the way to go. It may cost less than a service call and parts.

Get the electrician to check it. They did the work, they should stand by the quality of the work and fix it.

The Dometic RM 2820 was working last night. This morning it was not cooling and now the front panel and interior light are not working. No smell of ammonia. Any help with this challenge? Thanks,

Hope your tried switching off the machine for half to one hour, to re plug. Machine might re-set.

Alyssa redford, you need to show some official repairer to fix for you, because the problem is water damage, and solution for that is dissambly the device and clean touch screen connector on board with alcohol and let it dry for 2 hours, and then check again, if problem persist that mean you need to change the touch screen with new one. if you think you can do alone so look on you tube how to open device and do by yourself, if you are not sure if you can do please don't try at home without supervision of expert.Best of Luck. if my answer was helpful please rate it.

check your transformer some of them have a little reset button on the side if it arched it could of tripped it.if there is no reset make sure you have 24v coming into thermostat.

check washing machine wire plug. turn it open and check the wires.
are they fix accordingly.

One cause for this is that one or both of the check balls in the piston are frozen in place. This can be caused by drying paint on the check balls or seats or, as is the case many times in our area, if you did clean the machine well with water without any airless conditioner in it, sometimes the water dries and leave behind minerals that 'lock' the check balls in the seats. Set the machine up in water and turn it on to prime. Using a hammer hit the pump head where the piston is working fairly hard. You are trying not to break anything but knock the check balls loose. If they come loose and water starts cycling through the system, let run a while to wash anything out before switching to paint. If this doesn't work, you may have to take the head apart to see why the check balls won't free up. It could be because of peices of dried paint that won't come loose by themselves.

replace water level sensor switch about $140.00 dollars

The first thing that needs to be done is to disconnect the fill hoses from the back of the machine. Once disconnected, look at the inlet valve screens and check for blockage, if clear, open the water valves and check for water flow through hoses, if not clear, clean screens at fill valve, reconnect hoses & check for operation. If the problem remains, then the problem is with the machines fill valve & it would need to be replaced