These are the codes out of the manual below:
"PF" (Power Failure) flashes
Was the washing cycle interrupted by a power failure? Press
START to continue the cycle from the moment that power
was lost, - OR - Press STOP/CANCEL to clear the display
and completely cancel the cycle.
"FL" (Over Fill) flashes
The washer will beep every 10 seconds with no time-out. The
pump will cycle one half minute on, one half minute off, until
the over fill switch is reset or power is discontinued to the
unit. Press STOP/CANCEL to clear the display. Shut off the
water faucets to the inlet hoses if water continues to flow.
• "Er" (Processor Reset Error)
Cycle information was not stored during a power failure.
Press STOP/CANCEL to clear the display.
"LF" (Long Fill) flashes
Are the water inlet hoses kinked or clogged?
Are the water inlet valve screens clear?
Press STOP/CANCEL to clear the display.
• "CE" (Communications Error) flashes - beeps once
Press STOP/CANCEL to clear the display.
• "Ld" (Long Drain) flashes
Is the drain hose kinked or clogged?
Press STOP/CANCEL to clear the display.
• "CA" or "Cl" (Current Limit)
Is the washer overloaded?
Press STOP/CANCEL to clear the display.
• "Or" (Open Relay)
Washeroperation failure. Call for service.
• "Sr" (Stuck Relay)
Washeroperation failure. Call for service.
• "LS" (Lid Switch Error) flashes
Is the washer lid open? Close the lid and press START to
continue the cycle.
Is the lid closed? Open and close the lid. Press STOP/
CANCEL to clear the display.
• "SL" (Suds Lock)
Press STOP/CANCEL to clear the display. Drain/Spin load:
restart cycle. Do not add detergent. Use cold water.
• "dt" (Diagnostic Tests)
For service diagnostics only. Press STOP/CANCEL to clear
the display.
"ob" (Off Balance)
Is the load unbalanced? Redistribute the load. Close lid and
press START.
OL on my washing machine
1,004 views
Usually answered in minutes!
×