Whirlpool-KitchenAid-Roper Appliances: Oven Fault Codes:
>>Exception Note:<<
Chart below does not apply to Whirlpool Models using the "Y" line in the products model numbers. Applies to models using 4 digit displays only.
F0-E0 Analog to Digital failure
Disconnect panel for 30 seconds
Should the above error re-appear, replacement of the control is required.
F1-E1 Defective ERC Replace ERC
F2-E0 Shorted Keypad Replace Keypad
F3-E0 Sensor or Sensor Fuse Open Replace Sensor or Fuse
F3-E1 Shorted wire or Sensor locate short and correct it or replace Sensor
F3-E2 Oven over heat Replace Sensor
F3-E3 Cleaning Temp over heat Replace Sensor
F5-E0 Door Error Check Door
F5-E1 Door Latch Check Latch
F5-E2 Door Switch Check Switch
I had FSE1 as my error. Door would not lock. I tried it again, this time PRESSING ******* the door where the lock is. IT LOCKED! WHOOT!
SOURCE: tried to selfclean my NEW oven but get error message F5E1
Reading all the questions and responses - I had the same problem (would press "self clean", it would run for less then a minute then give the error message), so once I saw the code was E5F1 and what it meant (thanks for whoever posted that), I just pressed on the door for the first minute of the cycle, and self-cleaning then worked. Go figure :)
SOURCE: self cleaning electric range oven...lost instructions...need to ASAP
http://shared.whirlpoolcorp.com/product_literature/search_results.jsp?searchTerm=GR399LXHS&siteCd=WHRCOM
heres a link to your owners manual
Hope this helps!!
SOURCE: Self Cleaning Oven beeping and reading FSEO
Go in the back of the oven and there should be a tech sheet in a plastic bag. It will tell you what that code means. I assume it's a problem with the lock and switch mechanism. See what the code says it is
Hello friend, thank you for your inquiry!
I understand that your door is locked and you have error "F5E1" showing on your range. I would perform a reset on your appliance which can be done by flipping the household circuit breaker off for roughly ten minutes. If that does not correct the issue and you continue to receive the error "F5E1" I would contact a professional to come out and repair your appliance because it could be an issue within your UIB (user interface board) or main control panel. Hopefully this helps. -Matt
Hi,
Before you go working too hard to get
you oven to go into the self clean mode(self destruct)....check out
this tip...
Self
Cleaning Oven Problem
heatman101
"
Wish I had read this first. I never would have used the self cleaning
option. Thanks for the info!!
22,565 views
Usually answered in minutes!
I used the self cleaning feature on my Whirpool oven and now it won't unlock. How can I get it open?
Adam
my lock wont open after i self cleaned
After self-cleaning, E1 F5 shows and the door will not unlock on my Kenmore 665.95179300
Out of the blue my oven beeped and the E1 F5 came up on the display followed by the E0 F3. The fan turned on and would not shut off. I finally turned the circuit breaker off to stop it. What is this all about?
Everyone talks about the problem. What is the answer!! Please!
×