SOURCE: CLOTHES STUCK IN WASHER!!!!!!
If you open up the dispenser tray on the top of the machine, there should be a red cord. This is the manual release for the door. All you have to do is pull this cord and the door opens. If the cord is missing, you will need to remove the top of the washer to get to the latch. I hope this helps you.
SOURCE: Washer will not drain properly.
The splashing you hear is a liquid thats in the balance ring. This is located at the front edge of the inner tub that you spun by hand. It helps balance the loads. This is normal. The smell is a problem inherent to front loaders. About once a month run hot water wash with a cup of bleach in it, no clothes. Best bet is to leave door open to allow air to dry interior. I removed bulb in mine.
SOURCE: Maytag Neptune MAH8700AWW Front load
You must be on the right track, must be a blockage at the back of the soap drawer, check if junior has posted a toy car! If not turn down the water pressure at the machine stop tap
SOURCE: Suds in Sears Kenmore Elite Front Load Washer HE4t
I am having the same problem with the front load washer completely filling with suds and shutting down. We've had it for 2 years without problems, but it has now happened about 6-7 times in the past 4-5 weeks. We have not changed the amount of detergent, but we do not always use the same brand. I think this started after we began using the current detergent which is a 200 fl. oz. bottle of "Tide with a touch of Downy" Clean Breeze.
I think there is a good chance it is the Downy mixed in that is causing it or at least partially responsible.
I will switch detergents and see if the problem doesn't go away
SOURCE: Help!! My maytag neptune MAH6700AWW is having trouble.
the fix was simple i just had to lift my drain hose off the floor. it had become disconnected from the back of the washer and was lying on the floor. I didn't realize that by it lying on the floor it didn't provide the proper back pressure to keep the water in while filling the tub. this was the NF error. as for the LE error. i haven't gotten it since i took off my cold water hose connection and ran hot water into it to losen the dirt/rust that was caked into the screen that is located in it. My washer is running like it is brand new again.
751 views
Usually answered in minutes!
×