Question about Bosch Classixx WVF 240S Front Load Washer / Dryer

2 Answers

Bosch classixx 1000 washing machine - stops on spin

Washing machine stops at the spin cycle - light flashes. Have to drain water out manually. Happened last week and was then able to run an empty rinse cycle. Machine worked normally for another week. Same problem today but have had to drain water manually from the drum after trying an empty 90 wash and rinse cycle (both stopped on the Spin and flashed). Any ideas? Thanks. x

Posted by on

  • 4 more comments 
  • jodicks Jul 22, 2008

    I have exactly the same problem and the same machine



    Ours fails to empty after first rinse and then the spin light flashes - can sometimes move it on to spin cycle and get it to drain and spin but not always. Have tried cleaning pump filter etc as in the manual but still happens

  • kkbaht Aug 01, 2008

    Hi my washing machine has been doing the same too, at every other cycle it stops at spin and I have to manually drain the water and then try to run the machine again. I noticed it happens when I use the calgon tablets. Any advise will be greatly appreciated

  • Anonymous Feb 03, 2009

    bosch exxcel 1200 stop-s on sp-in and has to be drained , why

  • Jack Leevers Aug 27, 2012

    Ok, I know this one's old, but someone else might come on here with the same problem. I'm not sure for everyone but we: 1 cleaned out the filter; 2 took all pipe that drains the water out and gave that a good cleaning too. It was blocked with limescale and smelly crud. Now the cycle goes all the way through so that was our problem - not draining so not engaging on spin cycle. Cheap, efficient and extremely smelly! But fixed ... I hope ...

  • Greg Spain Jun 05, 2013

    had this problem. Found the belt covered in oil. Cleaned it and this problem went away. A week later now it does the same thing in the wash cycle. I see no one is getting an answer to this. Hope you don't buy a Maytag I wont again.

  • Anonymous Mar 16, 2014

    How to manually drain water panasonic washing machine type NA-F80B2

×

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Washing machine stops at the spin cycle - light flashes. Have to drain water out manually. Happened last week and was then able to run an empty rinse cycle. Machine worked normally for another week. Same problem today but have had to drain water manually from the drum after trying an empty 90 wash and rinse cycle (both stopped on the Spin and flashed). Any ideas? Thanks. x

Posted on Mar 21, 2010

Ad
  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Thre washing machine is stopping on rince, the light is flashing. we press start again and it goes through the same routine till it hit rinces and stops. the clothes are still full of water, we have to move the dial to rince and freshen up to finish the wash. any ideas..?

Posted on Jun 16, 2011

  • Jack Leevers Aug 27, 2012

    Ok, I know this one's old, but someone else might come on here with the same problem. I'm not sure for everyone but we: 1 cleaned out the filter; 2 took off the pipe that drains the water out and gave that a good cleaning too. It was blocked with limescale and smelly crud. Now the cycle goes all the way through so that was our problem - not draining so not engaging on spin cycle. Cheap, efficient and extremely smelly! But fixed ... I hope ...

  • ntrlnk44 Jan 03, 2014

    Check the door safety switch. Microswitches and magnetic switches will break. ,

×

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kenmore HE2 flashing lights


did the technician point out wat needs to be repaired

Aug 24, 2008 | Kenmore 46462 Front Load Washer

1 Answer

My Crosley CAW8350EW1 wash machine just stopped after the last spin cycle drained and the spin light keeps flashing. I'm wondering if that would be the timer or something else?


make sure that it didn't stop because of an unbalanced situation
as it is draining it should be turning slowly and as soon as it empties the spin speed picks and and the unbalance stops the machine

Mar 14, 2017 | Crosley Washing Machines

1 Answer

Hotpoint aqualtis washing machine model AQXXL 129 PM , runs through the cycle then stops at times leaving water in the drum and all lights flash why ?


the pump could possibly be jammed. you will need to drain the machine and remove the filter to check for any obstruction

May 17, 2014 | Hotpoint Washing Machines

1 Answer

Simpson 605 washing machine


it is worth having it properly diagnosed first before making a decision to spend money
could be a program board or start run capacitor

Nov 11, 2017 | Washing Machines

1 Answer

Machine lacked about 23 minutes in cycle, it stopped with lights flashing. It will not drain, therefore cannot spin. It just beeps whenbi try to start it again.


Good Day,
Your washing machine is fully automatic?
the washing cycle is normal?
if yes do the same maybe it will help you.
for the fully automatic washing machine mostly have drain pump, please check the filter of your drain pump, how? remove the cup of your drain pump like a ordinary cup, screw it clock wise or counter clock wise.
Remove drain pump filter and clean it, some hair pins, cotton buds or coins or any small item that coz of clog up.
if your washing machine dont have drain pump ,but fully automatic check the drain motor if running or not? how? open the back cover for top loader washing machine only, select spin cycle and press start to see the drain motor running? the drain motor is like a small box with small wire to pull the lever of the drain to remove water inside, if the motor running or pull the lever of the water pipe but water still inside the washing machine, remove the drain cup or cover and clean it or check if have coin or cloth inside that coz of clog or water stuck,
if the drain pump or drain motor is weak this is will cause and long time draining or totally not running the drain pump or drain motor and its cause of totally stop the cycle of washing machine in rinse time or spin time, because all fully automatic washing machine, after washing cycle the drain pump or drain motor must be on, to remove water before start the next cycle. rinse or spin cycle.

Nov 01, 2013 | Whirlpool Cabrio Washing Machines

1 Answer

Won't spin cycle


when sitting for the last spin it may be out of balance,when you have no cloyhes in it,put 1cup of HE clorox bleach and let it sit in tub over nite,then run on heavy duty wash hot water cycle.(no clothes) this should open up drain pump.this may take several trys.

Jul 31, 2010 | Bosch Washing Machines

1 Answer

Hoover hpe 236. water not draining, stops mid cycle, lights flash


Have you checked the pump filter, and or that the pump is actually working. if it spins o/k with no water in, then I would suspect a draining problem.
If filter clean and pump o/k, then it could be a control module fault. if this were the case, then it would probably be wiser to purchase a new washer.
Hope this is of some help to you.

Jan 16, 2010 | Hoover Washing Machines

1 Answer

Indesit washing machine not spinning - fault code timer and dor lock light flashing


my indesit washer/dryer wd12x programme dial goes all the way when it reaches spinning

May 30, 2009 | Indesit W 123 Front Load Washer

1 Answer

The washer does not spin during washing cycle or drain & spin cyc


I can a very simple part called the motor coupler...you can find the part at www.repairclinic.com. It costs 13.95. I am fixing my washing machine today, as this happened before and was the answer. Goodluck

Apr 11, 2009 | Kenmore 46462 Front Load Washer

Not finding what you are looking for?
Bosch Classixx WVF 240S Front Load Washer / Dryer Logo

5,076 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bosch Washing Machines Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

jimorris77

Level 3 Expert

411 Answers

Dw Wooten
Dw Wooten

Level 2 Expert

227 Answers

Are you a Bosch Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...