My Kenmore front load tumble action washer model number 417 is stopping mid cycle at the after rinse and won?t go to final spin automatically. Also it won?t draw any cold water into the machine an only draws water in if the machine is on warm or hot (on warm it is only drawing in Hot water. We then push to stop and turn the control to a point in the spin cycle where it will finish.

I have never ever seen a 'DO' code. All washing machine codes are E and 2 numbers, except for 'LOC' for 'Lock'..

https://www.searspartsdirect.com/diy/error-codes/washer-repair/1234598/kenmore-417-model-front-load-washer/0582

Try disconnecting from the mains supply for 15 minutes.

https://www.google.com/search?q=Kenmore+model+44082+error+code+%22do%22

..

What is the complete model number of your unit?

Mine was the door lock switch, $80. and about 20 mins. working like a champ.

If this machine is a Kenmore 417 Sourse (WCI) built washer with a font load,check tech sheet.I had the same problem on a Frigidaire frontload and it was the door latch/lock assembly.These machines can be tricky sometimes.Use tech sheet and make sure lock assembly ohms out ok.

replaice door swith

worn out drum bearings-mike

It's usually a control board problem. sorry for the bad news :(

take front panel off in the water pump rubber hose feel to see u can feelsomething in side the pump .this will cause the pump to stop/and not spin

When the washer initially fills for the wash, is it only hot water entering the drum? Try switching the water temperature between hot and cold as it fills. If any of them show little or no water getting through, it sounds too easy but check to make sure water supply taps are on, and that the cold/hot fill hoses aren't reversed. Remove the fill hoses and check any of the screen filters for blockage (in the hoses and in the inlet water valve). When the machine stops and waits to fill but all you hear is a hum, it sounds like there is power going to the valve but water is not able to get through it.
Good luck!

Snaggs, If your model number begins with 417 it could be a couple of issues. Start with the drain pump. Remove the bottom panel and see if the pump is clogged with coins or debris. It will be on the right. Check the pump impeller. Have a bunch of towells handy as you will have a lot of water coming out at you. When you drop the bottom panel you will be able to see if the belt is on in back. If this does not clear up the problem, more than likley it will be in the motor control board. Catriver...post back.