End of wash cycle (last 2 minutes,) F code, no spin & drain

WE HAD THE SAME PROBLEM. ONLY OURS WOULDN'T WORK ON THE "WHITES" CYCLE BUT WOULD WORK ON THE OTHERS. BUT IT WAS JUST A MATTER OF TIME BEFORE THEY WOULD ALL GO & THE REPAIRS WOULD BE $$$. YOU WILL EITHER NEED A REPAIRMAN & YOU'RE LOOKING AT A MINIMUM OF $200........IF YOU'RE LUCKY. DO YOURSELF A FAVOR & GET THE G.E. MODEL #GTWN2800DWW AT HOME DEPOT. LOOK AT IT IN THE STORE BUT BUY IT ON LINE (AS THERE MAY BE A $50 DISCOUNT). THIS WASHER IS WHAT YOU WANT. YOU WON'T BE SORRY.

It sounds like its a bearing

Hi valued Consumer, We would like to inquire further about your post with you. Please respond back to this email address [email protected] with your name, user id (Valued Consumer), phone number, street address, zip code, reviewer name, model & serial number, and date of purchase on the appliance.

Clean filters to the pump

replace control module at back right under tut on the base

Just had the exact same issue with my F&P it would stay in the drain cycle(without draining). It would show 2 minutes left in the cycle, dropping to 1 minute, but would never complete the cycle.
For some reason the machine would not drain the water from the drum and would continually remain in the drain cycle, spinning the load(back & forth), but not draining the water.
----------
This is how I sorted the machine: -
1. I turned off & unplugged the machine.
2. I drained the machine manually. Opening the manual drain compartment located at the bottom right of the machine.
a). Firstly drained the majority of the water using the small black hose into a plastic container(ice cream container will be fine). Took a little while as the machine was quite full and I also didn't want to flood the laundry.
b). Once I had drained most of the water I undid the filter plug to drain the remainder of the water, which wasn't too much & was able to mop up with a towel. I gave the filter a good clean, removing as much build up in there(which in actuality was very little lint, gunk, etc. Though I did find a small button & a collar stay wedged in there).
3). I blew very hard into the washing machine drain hose a few times(read this on another forum so thought I'd give it a try!). Use a plastic bag, etc. to cover the hose etc. for hygiene purposes :)
4). I then plugged & turned on the machine. The machine went straight back into the 2 minute drain cycle. It attempted to drain/pump remaining water, however this time machine successfully went through the 2 minute drain cycle. Machine stopped, counted down, click and I was able to open the door.
I put the washing through a rinse setting to see whether the machine would complete cycle. I can happily report that the machine completed the rinse cycle on the washing with no issues. I also put through another load to see if it would complete a full wash cycle, which I can report it happily did so.
This may have just saved me a grand$ :)
Good luck.
cheers
Monkeyboy :^)

Hi I hope this helps....

www.managemyhome.com is a site run for sears. You can check there for more help

you have blockage in you drain plug. to solve this problem you'll have to remove the lower front panel of your machine by removing the 3 (1/4") screws on the vary bottom of the machine. once the panel is removed you'll see a 1 1/2" white PVC drainage plug. turn the inner plug to the left in till open. (WARNING ALL THE WATER IN THE DRUM WILL DRAIN THOUGH THIS PLUG) remove debris likes socks or everything that's there replace the panel and your all set.

Hi
My name is Gloria, my neptune washer will not spin on the last spin cycle of any of the washing cycle. A code of uC comes up.