Sears Kenmore 80 Series Model 110.29842991
Machine will not drain, therefore will not go into the spin cycle? What can I do?
Thanks
[email protected]
Check your lid switch. If the lid switch is not making proper contact, or is broken, the washer will fill, agitate (some model washers won't), then just stop when it gets to the spin cycle. If this is what you are experiencing, then this could be a quick and easy repair for you.
Try opening an closing the lid. If you don't hear a clicking noise when the lid closes, the lid switch may be bad or loose. It is mounted under the opening of the tub rim on the right-hand side and held in place with two screws. Make sure the lid strike ( a small plastic piece) is present on the lid as well. This closes the switch contacts when the lid closes. If the lid switch does not function, the washer will not complete a wash cycle.
If the determine the switch and/or lid strike is broken, searspartsdirect.com carries the parts need. Just type in the model number you provided and you will find the lid switch under the "Top and Cabinet" heading as item #11 (part #3949238). The Lid Strike is under the same heading as item #20 (part #350733).
If you need advice on how to replace the lid switch please post back and let me know.
If I'm off the mark here, please post back with comments and give me a little more elaboration on what your washer is doing or not doing.
PS You do not need to drain the tub to replace the switch. If you wish to drain it, however, and want to by-pass the lid switch, I can give you instructions on how to do this as well.
I need advice on how to replace the lid switch
4,093 views
Usually answered in minutes!
I have the same problem, and I was able to determine the switch was bad, If possible could you give directions on how I can replace it myself. At first glance it looks like removing two screws and unplugging the cable. And reverse to install. Is the so or do I need any special tools?
I have a kenmore model 110 washer that will not drain or spin. How do you bypass the lid switch to see if it will drain?
kenmore 70 washer will not go to spin and drain after the rinse cycle. i have to manually turn the knob to spin to make it work
how would i know if the lid switch is broken. please give me instruction how to drain water while lid switch is still broken
Kenmore Heavy duty 70 washer drains but won spin does not seam to be the cycle timer the drum does not turn.
2 cent fix is to wire nut 2 of the 3 wires together bypasing the switch leave the ground alone , who cares about safty, NOT a fire hazzard if it comes losse it will just not work!!!
It no longer drains in the spin cycle
×