I think I need your help WITH MY Haier HPL21E portable washer.
WASH CYCLE: The tub agitates 3-4x then beeps with the 3 flashing lights [wash; rinse; spin]
The flashing stops and the wash starts again. This time 1 agitation followed by beeps & flash for only a few seconds;
then it starts the wash again.
SPIN CYCLE: The only way I get it to spin for at least 5 seconds is turn the machine OFF; Turn it back ON: select SPIN cycle only; press START and 5 seconds later the spinning stops.
I just heard water sloshing underneath the tub. Is there a way I can check to see if there's a lot of water pooled under the tub?
Could this be the reason for the agitating and spinning problem.
I wish I could afford a repair service, but I'm stuck figuring this out by myself. Any help is greatly appreciated. Thanks in advance.
Ps. There's oly a small load of clothes so its not an overloading probem
SOURCE: Agitator moves slowly on wash cycle/not at all on spin cycle
it sounds like the dogs are worn. try twisting the agitator post by hand,it should move freely in one direction then lock up going the other.its a pretty easy fix if they are.pry off the top of the agitator post off then remove the cap inside,there is a bolt that holds the post down.i'm pretty sure it's 7/16 in. once the bolt is loose,lift the whole agitator out of machine and with your hand inside post turn it upside downand let the dog holder slide out.watch how the dogs fit into the holder, replace with new dogs and reverse the removal process.
if the machine wont spin, check the lid switch. thats usually the cause of a no spin situation.other than that a wet vac is your best bet.hope that helps.
SOURCE: Whirlpool top Loading washing machine won't spin on spin cycle
If the washer won't finish a spin cycle, it probably means that your timer went bad or stalled. You can take the control panel off and look at the contacts for scorching or corrosion.
SOURCE: Whirlpool LXR9445JQ having trouble with spin cycles.
Check the motor and make sure that the RPMs are high enough, Also check the tension on the belt
SOURCE: agitator only turns clockwise (Whirlpool top load)
You will need to replace the dogs under the agitator, they are pretty easy. Just pop the cap, take out the center bolt, remove it the dogs are 4 teeth looking items.
585 views
Usually answered in minutes!
×