How do i set the child lock on frigidaire dishwasher FDB1502RG ?

Do the same again. It is a Toggle On, Toggle Off. Normally Press and hold for 3 to 5 seconds.

How do I set the child lock feature? - Dishwashers

Frigidaire https://www.frigidaire.ca > ... > FAQs > Dishwashers
Press and hold DELAY START for 3 seconds. An indicator light on the lock graphic pad will illuminate when the controls are locked and no new selections can be made..

..

what can cause the spray arm to get burned? is it too hot water in the water heater or the heating element ?

Hi,

The scum, film and white residue problems have started since the reduction of phosphates in dishwasher detergents.

Here is a tip that will help you to solve the problem of films, residue, and scum in your dishwasher.

Dishwasher Residue and Film on Dishes

heatman101

Try using a dishwasher cleaner. ou can buy these atyout loca supermarket.

Check the timer control.

Reset the dishwasher by switching the breaker off for a couple of minutes. this will reset the dishwashers electroincs. If nothing else is wrong this should do it.

Press and HOLD the lock button down. It toggles the lock feature when you hold the button down. The lock light went off and the unit works again.

WOW! This same thing is happening to me tonight too! The Lock button is lit for me but not the "heat dry". Looking forward to reading what this problem is.

After you turn off the power to your dishwasher, you can inspect the dishwasher with a flashlight to find where the melting happened. If it is near the circle that is the heating element, you can suspect the timer froze during the drying cycle.

But also open things up and look for shorted/melted wires (in the door panel and under the dishwasher.)

No matter what you find, if you have proof of purchase for your dishwasher, I would press for repair/replacement from the manufacturer.

Good Luck!

Error CL means that the child lock had been activated.
To unlock the machine you should put your finger up inside the handle and locate a slider switch, then push the switch to to the left side.