The compressor is the part which cools the refrigerator.----------
First i will explain the working procedure of your sanyo refrigerator.----------
In the refrigerator, there is a part called compressor, the compressor is the part which cools the freezer section,
When
the freezer reaches its cooling level the defrost cycle starts functioning. In
this cycle the fan in the freezer section starts running and the cool air in
the freezer section is passed to the fridge section and the fridge section gets
cold.--------- So the freezer section cooling/ freezing is must.If freezer is not getting properly cooled or not getting cooled, then fridge section will show the low or no cooling problem.--------------
In your refrigerator, its quite possible that compressor is got weak, nor complete faulty but little bit weak.So when you open and close the fridge or freezer door , the compressor is not that strong to maintain the required temperature.So its working hard to cool inside temperature, but its not doing it quickly as it should.---------.----------
In the compressor there is a refrigerant called FREON.With the help of this
Freon the compressor cools the freezer section.Freon is a gaseous type cooling
agent.The compressor will stop cooling when coolant gets leaked from its
chamber.--------- Again
recharging the Freon is possible, but the cost for that recharging is approx
the cost of new compressor.So its always advisable to get compressor
replaced.Because new compressor has warranty for few years.------------------ You can get required parts
from from online sites like: --- www.repairclinic.com or from searspartsdirect
online site. --------- ----------------
There is manual reset procedure, sometimes the ice gets frosted all over and blocks the ventilation's for cool air to pass from one section to another, and this also causes problem.So directly going for compressor inspection, before that you can try manual reset procedure and see if that helps.---------
The manual reset procedure is as follows : ----
First unplug the unit from main power outlet. Then empty whole unit
completely. Then keep both the doors open. Wait for 24 hours. All the ice
collected on the coils and in the freezer section will get melted.
Clean the water from the sections. Then Connect the power cord of the unit to
main power outlet after 24 hours/.Then set the temperature to normal in both
fridge and freezer section. It will take approx 4 to 6 hours for your refrigerator to regain its regular cooling/ freezing .So after 4 to 6 hours check , Is the refrigerator cooling properly or is it taking time or temp is dropping once you open close door. If this problems are not noticed, then reset procedure has helped.------- But if same problem is noticed after reset procedure is followed, then you can get the compressor checked.
--------
This should help.
Thanks.Helpmech.
×