Need instructions on replacing pump on Oasis Washer

Check out the videos.

https://www.google.com/search?q=kenmore+elite+oasis+washer+pump+replacement

..

If your washer start going to high speed and it make unbalance and bangin on the frame. there was a stator may need replace....good luck

Hello,

The video below explains how to access and replace the washers man control board.

http://www.appliancerepairlesson.com/2011/02/23/cabrio-bravos-oasis-f1-error-washer-repair/

sounds like a gearbox oil seal,which are not normally replacable tie to replace it

See the Whirlpool Service manual for the Cabrio washer:

The Sears Oasis is basically the same machine:

https://secured.whirlpool.com/Service/SrvTechAdm.nsf/2cd44500d572193285256a45004fd9d6/409753510a90c8be852571e90073421b/$FILE/8178583.pdf

LD code is long drain,one of two things the drain pump is frozen and need to be replaced or there is somthing in the pump.Pull the washer away from the wall a bit and get a bunch of towels.Lean the washer back against the wall towards the middle in the back you will see the pump take it apart and find the clog.

The drain pump evacuates the water from the tub and down the drain pipe. There is only a solenoid valve assembly to let water into the washer.

On this washer, the dl code indicates a failed lid lock mechanism. Pressing pause/cancel should reset the controls.

You may have to unplug the unit for 20-30 minutes, then restore the power.

If that doesn't work, the only other solution would be to replace the door lock assembly.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

It needs disassembled and requires special tools.

LD code is long drain one of 2 things the drain pump is frozen and need to be replaced or there is somthing in the pump. Pull the washer a way from the wall a bit and get a bunch of towels. Lean the washer back against the wall towards the middle in the back you will see the pump take it apart and find the clog.
it can be assessed through the bottom.