WM1832CW has stopped spinning. Tries to spin but

Well it could be clogged. I that case machine should be open at the bottom and take down the hose that connects to drum.

Here there are multiple problems it is probably electronics. Unless you find some cheap replacement that machine is gone.

There is a problem with the programming of the control board if this is occurring.

All you can do is turn off the water to the machine at the end of the full cycle and then run the spin cycle again to dry out the clothes. Then no water can enter the wash drum.

Otherwise you would need to turn off the water each time before the spin cycle concluded and thus before the machine began adding water again.

MOST LIKELY THE MOTOR IS SHOT OR THE BELT AROUND THE DRUM CAME OFF THE DRUM

with a lot of the machines now they wont go into spin mode if the drum is not balanced properly, like say you had a load of towels in their, well it wont spin as its to unstable to spin without wobbling around so it simply stops at the spin cycle and does nothing, you can try this by turning it on with no clothes in and see if it will go into the spin cycle with no clothes in, if it does then chances are its not weighing the clothes properly and would end up costing a fortune to put right as it sounds like you spent a lot of money on parts all ready, so give i a try with no clothes in and see if it will spin, have you tried turning the drum by hand when its switched off to check for any grinding noises or jerking when you try to turn it by hand, im not sure how the balance sensor works or even where it is as its a new feature in the last few years but people are now starting to have problems with this feature and it stops the machine from spinning leaving the clothes soaking yet, so give it a try empty and see what happens

probably belt was spill out or broken

error code means motor overload...it just confirm my diagnosis ma'am...

machine wont spin just turns back and forth

1. press POWER button to turn om.
2. press SPIN SPEED button only.
3. press START/PAUSE button/

bad motor most likely. easy fix

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

I think you will find that if you check the brushes, you will probably need to replace them.