I have a Kenmore washer model number: 110. 82427130. I need the washers large selector knob. Where can I obtain a replacement?

Good afternoon friend, that's a great question!

I understand that you are trying to replace the selector knob on your Frigidaire washer, GLTF2940E. Normally this is not a DIY job and we would recommend having a technician come out to the home in order to properly disassemble your front panel and replace the selector knob as needed. Hope this is helpful. -Matt

The selector switch is intermittent.

Post your model number for a more specific answer.
Please rate this answer.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Just get the model number of your machine and buy a new one, you cannot fix it by trying to assemble again, spring had pressure, it may hurt you if you try to fix it, It is much advisableto replace it with new one

I've found the timer the part number is AP57236 but you have to call www.appliancepartspros.com 1-877-477-7278 It requires special attention. The timer knob is part number AP3099107 and cost $20.28 If anyone can help find the parts you need these people are great to work with and their price and shipping charges are very reasonable. I hope you find the answer that you're looking for.

go to sears .com,click parts put in your model number(should be inside the dryer door)and get your part.or repair clinic.com-mike

If it fills up to normal level on other settings then the water selector switch is bad.

Look at the back side of this switch and you should see a tube connected from the switch to the lower part of the tub. Take the tube loose at the switch and blow through to check for any blockage. Look at the tube for holes.

I believe the selector knob on a Whirpool just has to be turned counter-clockwise with the selector pushed in. It will spin off the shaft and then the outer indicator dial will pull off. The shaft also has a keyed slot that will only allow the dial to be removed and installed one way, so there should be no question as to how it goes back on.

Was there a reason as to why you are removing the washer selector knob? If this is a simple matter of replacing a broken water temperature selector, you shouldn't have to remove any of the control knobs to gain access to the selector. The entire front panel comes off by removing the screws holding it in place. That way you can access the broken selector from behind the front panel much easier. Just remove the panel right above the washer top (under the dryer) and it should expose the front panel mounting screws. Remove these screws and the front panel comes off. Just make sure the unit is unplugged before you begin. I hope this helps you. Let me know if you need further assistance.