Amana washing machine will not spin. it agitates & the water drains out fine.

Question edited for clarity, 'Amanda' to 'Amana'.
Question moved to maker category.

It is sensing, and that you have something that needs a 'Delicate' setting, or a 'Woollens' setting. It provides water and very little agitation that might damage or stretch the clothes. Read the manual.

Google

Amana (model) manual

..

if this is a top loader put a pencil into the lid switch opening if the machine spins and drains when the timer knob says it should the tab on the lid or the lid switch has failed...replace the switch or the tab that goes into the lid switch opening

Washing Machine Will Not Agitate or Spin - Home Repair ...

? 15:00
www.youtube.com/watch?v=wUSmUSWWIS4
Oct 20, 2013 - Uploaded by Robert DIY This washing machine would not agitate or spin. There is a ...My washer also is not agitating or spinning but water will drain after a long while.

Troubleshooting Why the Washer Won't Agitate ' PartSelect ...

? 3:10
www.youtube.com/watch?v=LfWRyt1vj2w

Nov 5, 2012 - Uploaded by PartSelect
The only wash cycle that works is delicate none of the other washcycles work .... The washer still fills, drains and spins to dry butwill not agitate. ... Hi My machine wont spin or agitate on heavy loads like a few towels etc (fine

The pump needs to be replaced. The pump controls the agitation for the wash cycle, also controls the tub for draining & spinning after the wash & rinse cycle. The belt has nothing to do with it. Pump is very simple to remove & replace, and not too expensive, it's plastic.

You will likely need to replace the drive bell and agitator. Here is a diagram and parts list for your unit.

Hi

for the question of water comming in the spin cycle, yes its normal we call it a spray rinse. For the shaking check your leveling and also make sure that the back leveling feet when lifting back of washer up and down that the foot mechanism is functining.

Hope this helps

That sound like the motor coupler is bad. Here is a link to the parts.

Hi,
May be the spinning coil is short circuited kindly replace the motor even if you find the same probelm means then you are suppose to change the operational panel

your problem still could be a bad lid switch not making. also, check your spin/agitate belt part #40053606. hope the attaced breakdown helps.