My washer goes through the cycle but the cold

If it doesn't fill for the rinse, I would say that the cold inlet valve has failed. Check that the cold tap is turned on and check when the machine fills for the wash cycle and see if it is taking hot or cold water. You will probably find that it is filling only with hot water. A local spares store should have the valve you need.

if it fails to stop running only at the rinse part of the cycle it is probably in the timer as the solenoid valve has to cut the water off when the washer fills for the wash cycle too. fills for wash cycle and cuts off water, washes and drains, refills for rinse cycle and water just keeps running? does this every time you run it? that's in the timer. bad solenoid (water inlet valve) would keep running even on wash fill up. hope this helps.

You need to clarify EITHER Cold or Hot water. Usually it's the Cold water relay switch is "Stuck". You can remove the top of the washer (Un-Plug the dam thing first). Facing the washer like you normally do, Look to the mid-left, back of the washer. There are Two VALVES (COLD-COMPLEX AND HOT-SIMPLE). These are solenoids which are just a magnet that goes up and down when powered. You can "gently" tap each one with the handle of a screw driver. I herd that this works (It doesn't) so replace the Cold Water Valve (Expensive) about $40 +/- $10. The Easy one (Hot water) is only $12 and has one solenoid. Of course if One fails, the Other one is just waiting for you to complete THAT job to fail a week, month, or 10 minutes later. So do them both, throw them away, and then your water will fill as IT IS SUPPOSE TOO!

If you need further help, reach me via phone at https://www.6ya.com/expert/steven_b77d19396bfe2249

Has it always done this or just recently? Some washers have lower rinse fills then spray the water on the clothes as it goes through its cycle.

all rinse cycles are filled with cold water to keep the clothes from wrinkling.set up the washer to run with just cold water.start it,if no water comes into washer,shut down your house water valve that fills the washer,take off the cold water hose,stick it in the washer or if there's a sink or where ever and turn on the water,if water comes out of the hose then you need a new water valve on the washer

Most likely the cold water valve. Easy fix

The cold water solenoid valve or the controller is defective. It is more likely that the valve is defective. Of course, check to make sure that the cold water feed is turned on.

Hi!
When the cycle doesn't advance, it's probably the timer or a cold-water supply problem:
It's the timer, if your washing machine fills with water and begins agitating, but the timer never advances--or if the washer is in a spin cycle and the timer won't advance. Then you need to replace the timer.
It may be a cold-water supply problem, if the washing machine fills with water, agitates, drains, and spins, but then doesn't fill with rinse water. See There's no cold water.
Please do rate this solution as FixYa and revert for further assistance.

Thanks
Rylee

replace the water inlet valve, the valve that the black hat and cold lines connect to

your cold water valve will be your problem or you've turned the water supply off, if the supply is not off put the machine on to the final rinse if it fills it will be the main rinse valve gone. The cold water valve is a double one with 2 solaniods. Unplug the machine turn water supply off remove fill hose there are 2 screws keeping the top on, remove them lift the lid off.undo the screws that keep the valve on, take note wiring and remove pull the black hoses off, replace with new one. The resistance of the valve will be around 3.4 kohms