Question about Indesit W 123 Front Load Washer

1 Answer

Indesit moon not spinning as it should

Hi
my Indesit Moon does not seem to be spinning properly. At the end of the cycle, the sheet and duvet cover i'd washed were still very wet. As I'm sure you know, there isn't a separate spin cycle on this type of machine (it's major design flaw as far as I'm concerned) so there is no way of spinning it a second time. Is this a common problem, and can anything be done about it? thanks in advance.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 825 Answers

My machine is similar...............but has an extra rinse button which adds 5 minits to the wash.....but spins faster to get rid of extra water...............see if you have extra rinse option......

cheers

Posted on Jul 24, 2017

Ad

3 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
Bob Gemmell

Bobby G

  • 212 Answers

SOURCE: I need to replace the seal round the door but cannot remove the old one

Take the top panel off by removing the two screws underneath the lid at the rear and look down inside towards the front door edge of the drum you will see a very large metal hose clips holds the door seal on. A screwdriver will loosen the clip then the clip will slip off and then the seal can be removed and replaced

Posted on May 29, 2009

Anonymous

  • 1 Answer

SOURCE: Have the Indesit Moon washing machine and it will

when i purchased this machine i too had problems with machine getting stuck in cycles (mainly the 60deg)for hours and black marks apprearing on seal. when i looked into it i was told to check the height of the outlet hose. mine was too low down the pipe which causes the machine to cyphon. water is going out of the machine as soon as it is put in. this machine has an automatic rinse feature which will keep rinsing until all detergent has been removed from clothes. if the water is going straight out then the machine cannot rinse so tries to fill again (neverending cycle. also meant that i could not successfully wash on 60deg. bacteria thrives in lower tempretures hence the black mould on seal. after adjusting the outlep pipe the machine has worked like a dream. i also do a service wash once a month. run machine on hottest wash with no clothes in using bio powder. this cleans out the machine and kills any lingering bacteria. it has to be done with powder though because it contains bleaching agents. no smells now. hope this helps all those having problems.

Posted on Jun 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Indesit moon not spinning


replace the timer or control board .

Nov 11, 2015 | Indesit Washing Machines

1 Answer

How do I get the moon cycle on the top to work?


The easiest way to set the moon dial is to find out when the last full moon was, then turn the moon dial by hand to where the moon is straight up under the 15, then move it clockwise on click per day since full moon. If the last full moon was last Fri., and today is the following Tues. then you would move it a click for sat., one for sun, one for mon. and one for Tues. If you try to turn the dial, and it resists, wait till a couple hours later. Hope this helps

Feb 16, 2015 | Howard Miller Majestic Grandfather Clock...

1 Answer

WSM2480 Clothes Still Wet After Slow Spin Cycle


It's possible that the tub didn't drain properly in the allotted time and the remaining water is slowing your drum from coming to maximum extraction speed.

Jan 10, 2014 | GE WSM2420D Unitized Spacemaker Washer /...

1 Answer

Hi When I try to take pictures of the moon at night, the all I get is bright light without any detail. The sensor seems overloaded and the image seems smudged. I have tried with the intelligent...


All automatic-exposure cameras try to render the scene as a middle gray. The moon is a small portion of the total image, so the camera concentrates on the sky. In trying to get enough light to make the sky go from black to gray, the moon gets completely overexposed. What you want is the moon properly exposed, even if that means the sky goes completely black.

For a full moon, you want the same exposure you would use at noon on a bright day. If you think about it for a moment, it becomes obvious. The full moon is simply a landscape at high noon. Unfortunately, the camera can't know that.

Set the camera to manual. Start with the "Sunny-16 Rule", which tells you to set the aperture to f/16 and the shutter speed to 1/ISO. So for example, set the ISO to 200, the aperture to f/16, and the shutter speed to 1/200. Look at the result on the screen and adjust the exposure as needed.

That was for a full moon. For other phases you may need to add exposure, but the "Sunny-16 Rule" will still give you a starting point.

Jun 18, 2011 | Panasonic Lumix DMC-LX3 Digital Camera

1 Answer

I have the indesit moon washer. The red door lock light is flashing when i start the cycle which is stopping the washer from going. The door is locked properly and there is nothing caught in it.


Just sorted this problem out, wife said just b4 leaving for work,oh love the door on the washing machine wont open and theres a red light on,,OMG i thought, as she said she would find the instructions when she gets home, so i got the corless drill out and a big hammer,( not needed,) lol just turned the power off and after 2 mins the door unlocked and was able to get all the clean wifes undearware out, cheers all and hope this helps

Oct 06, 2010 | Indesit Washing Machines

1 Answer

I just bought a Miele s558 Silver Moon, seems like


good vacuums bags are very expensive and parts too
return it

May 11, 2010 | Miele s558 Silver Moon Vacuum

3 Answers

My Indesit Moon 1400 has stopped working. Shortly after the cycle starts the blue LED lights at start and 40 deg flash rapidly. Washing inside machine is soaking wet but has neither washed nor spinned. ANy...


Tom, I'm having exactly the same problem, Have you managed to solve it? The Service center will no even tell me what's wrong with (they're quite keen to get me to arrange a visit from their engineer for £110 though). Thanks

Jan 30, 2010 | Indesit W 123 Front Load Washer

1 Answer

Indesit washing not completing cycle, washing very wet (ie not spinning) ny thoughts appreciated


Check the pump filter is not clogged up, this should be at bottom front right of washer, possibly behind a removeable cover.
If clean then it could be the brushes in the motor that need replacing.
Hope this helps.

Jan 16, 2010 | Indesit W 123 Front Load Washer

Not finding what you are looking for?
Indesit W 123 Front Load Washer Logo

Related Topics:

181 people viewed this question

Ask a Question

Usually answered in minutes!

Top Indesit Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

peter gittos
peter gittos

Level 2 Expert

247 Answers

jimorris77

Level 3 Expert

411 Answers

Are you an Indesit Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...