The iron does not heat up

It is damaged in side and could be dangerous , do not use till it repaired or replaced .

https://www.hotukdeals.com/discussions/descale-light-on-morphy-richards-43330-power-steam-elite-2626695

https://www.amazon.co.uk/ask/questions/asin/B006JX4VN4

https://www.mumsnet.com/Talk/housekeeping/741113-Steam-generator-iron-problems

https://www.morphyrichards.co.uk/Pdf/IB42242.pdf

Try cleaning the iron with vinegar. Here is a link to show you how.
Cleaning Clogged Steam Iron

If the iron heats but steams improperly, inspect the soleplate and clean the vents and flush sediment out of the steam chamber.
If the iron produces too much or too little heat, test the electrical cord . Also test and, if needed, adjust calibration of the thermostat .
If the iron does not spray properly, inspect and clean the nozzle (see below).
God bless you

Hi,

No,
either the thermostat or a sensor is bad..

Here is a tip that will help you to troubleshoot your iron and figure out what is wrong with it.

Electric Iron not Heating Up or not Working Right
http://www.fixya.com/support/r5300202-electric_iron_not_heating_up_or_not

heatman101

Hi,

Here is a tip that will help you to troubleshoot your iron and figure out what is wrong with it.

Electric Iron not Heating Up or not Working Right
http://www.fixya.com/support/r5300202-electric_iron_not_heating_up_or_not

heatman101

Hi,
Try using different water...

Here is a tip that will help you with that problem...

My Steam Iron is Leaking Water
http://www.fixya.com/support/r5301301-steam_iron_leaking_water

heatman101

Sounds like the Steam control valve is blocked or not opening. try cleaning the iron with a kit from wallmart or similar store. Failing that :It may be cheaper to buy a new one from wallmart or similar store.

Recommended solution, gently shake, did not work.

Considering the iron was at a minimum two years old, I decided to purchase another Rowenta. I found the recommended solution documented on a FAQ sheet enclosed with the new iron.

I actually own another Rowenta iron (I now have three) that has the same issue. I will send one iron, the one manufactured in Germany, to a Rowenta Service Center to see if can be repaired - it was the first Rowenta iron I purchased and it provided several good years of service.

take down the iron and clean it the holes at the bottom of the iron are clogged up.good luck.