If this machine is like other of its type then you may find the manual taped to the inside of the machine near the bottom side panel.
open the bottom access panel (3 screws on bottom front lip) and look for it as it will have the codes. near where the filter is .
while you were down there cleaning the filter did you check that the pump impellers move freely and were not clogged with any debris.
SOURCE: error codes
if this is a fridgidaire washer, I guess it's a clogged coin catcher. You have remove the front access panel and clean it out. I am working on that now.
Ok if its only bring the E20 up on the drying side then this will be a blocked dryer condenser chamber.
To get at this you need to take the back half of the washer off and from there you will see a big plastic chamber going from the bottom up to the top.
Take this chamber off and give it a good clean out with a hose pipe.
Once this is clear refit it and the dryer should be back to normal from there.
2,028 views
Usually answered in minutes!
My Washing machine Daewoo Lavadora DWD-F1011 stops working after 10-15 minutes of "normal" washing and displays error code F8. Cannot find what the error codes mean. I would appreciate any suggestions or the error codes. Thanks
during the wash cycle, I think when it is draining and beginning to spin, my maytag front loading machine that I bought in the summer of 07 stops running and gives me an error code of f-09. I can some times get the load to finish if I switch it to rinse and drain. Sometimes this also gives me an error code of f-02
Well you posted this under a Maytag Epic the fault code for an Epic E20= Nothing there is no Fault code for that under the Epic. I dont have any info on the Daewoo (KOREN) machine try to repost under Daewoo
i have a daewoo washing machine that comes up with an error code E8 when there is about 20 minutes left on the timer - dont know what it means though??
NOT WASHING NOT RINSEING NOT SPINNING
×