Fault code hi we have whirlpool 6th sense wasing machine and the fault code FH is coming up after 5min on a rapid plus wash any ideas?

There is a live contact with the repair guy, you can try that.

We have just bought a whirlpool zen 6th sence when we tried to do 1st wash without clothing we couldn't get the programme dial to move or wash to start. It just has 6.00 and a washer and 8 on its side symbol

washers are very expensive to fix they cost more to fix then to buy

Dispenser Circuit Error Re: Jeff

f23 code can be generated by loes wire connect to heat element are pump motor test out the pump check for lose wire

The F05 fault is nothing to do with what soaps you use.. Its a little red wire located at the front bottom centre of your aquasteam washer that has come lose or detached. A task to get to it but pretty easy and dodgey repair men would have your pants down for such a simple thing

hi,
looks like there is some friction between the main and outer tub of your machine. there is generally a mechanism for smooth spinning of the machine in good rpms for wash-spin cycle. this could be because of rust formation, or mud collection. please refer your manual and remove the 3 screws behind the lower front plastic cover, and look for rust formation. scrape the rust and try spinning again.

cheers

FH is the code for no water flowing in...

is there water flowing in?

if there is none, the water solenoid is the problem,

if there is water going in, then the flow switch is the problem.

here is the transcript from the web..

FH ERROR CODE

No water detected entering machine or Pressure switch trip not detected.
If after 30 seconds the control does not detect water entering machine and then valves
will be turned off and the error code will be displayed.
Or
If the control has turned the water valves on and after 8 minutes the flow sensor has
detected 48liters of water passing through it, but has not detected the pressure switch
trip, the valves will be turned off and the error code will flash.

and here is their solution

water source opened
flowmeter
pressoswitch
wiring to valves, pump,
flowmeter, pressoswitch
hoses


either one of those parts...

tnx 4 using fixya,

drcool

my whirlpool 6th sense will not start all lights and power i think that it is the door sensor at fault? The green light door locked light is not on.

hi,

i have a whirlpool 6th sense washing machine, it has come up with clean pump, does anyone know where the pump is on the machine, as i have lost my instruction manual.

regards

jackie