Question about KitchenAid 32685 Mixer
This can be caused by a number of things. The first thing to check will be the carbon brushes located on the left and right sides of the unit. Just simply unscrew the caps with a straight screwdriver. Once removed your can clearly see the shape of the carbon brushes. If they appear to have little or no wear and aren't broken, this won't be the cause of this problem. Also take note when you take them out AND put them back in as they willl only fit ONE way. The next thing to check will be the main control at the rear of the unit. After removing the power source, you can also remove the rear access panel. A phillips screwdriver is required. Next after removing the panel, you can now see the main board. Inspect it for any immediate signs of broken or burned wires also check the bi-metal on the control itself, as this will often indicate a faulty board. If however, everything looks good visibly and you still have no power to the unit, the last possible solution could be that the power cord itself has an internal problem. Hope this helps
Posted on Dec 02, 2009
Electrical parts can appear to be good but can still be bad. They must be tested by somebody qualified in diagnostic procedures of electrical problems.
Most likely the cord won't be the problem unless it's where the cord terminates or the cord flexes during use. Constant flexing will cause wire to break eventually and sometimes even the best assemblers in the world can muss up a terminal connection. This can even pass quality control as they only test if the connection is made (one out of the 22 conductors can be made and it'll pass the QC check and the first load that's put on it will blow the one wire that should have been 22 times as strong) and not if it will handle a load. mind you, it was the fault of the assemblers, not the user.
The individual components such as resistors, capacitors, diodes, transistors, and other things failure rates are actually based on the purity of the components that made them and the cleanliness of the room they were assembled in. For a well designed piece of equipment, you can expect the failures to be because of these reasons. for not so well designed pieces... you get the idea.
Last thing you have to consider is the craftsmanship used in assembling the item. Was it designed and assembled to last forever or was it designed right using correct materials but assembled by somebody that didn't even care if all the parts got in correctly.
Posted on Jan 26, 2013
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Jun 27, 2016 | KitchenAid KSM150PS Artisan Series Stand...
Dec 21, 2014 | KitchenAid Food Mixers
Nov 23, 2013 | Hobart D300 Stand Mixer
Jan 20, 2013 | KitchenAid Food Mixers
Feb 18, 2009 | Sunbeam Food Mixers
Jan 01, 2009 | KitchenAid K5SS Heavy Duty Commercial...
Mar 18, 2008 | Hobart H600 Stand Mixer
Nov 12, 2006 | Sunbeam 2485 MixMaster Series Hand Mixer
35,812 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: