My 2.5 year old Bosch Nexxtg 500 WFMC3301/UC washing machine fills then drains. Does not complete wash cycle. If I leave off for a couple of days it will fill then drum turns for awhile, but will not complete cycle.Have checked pump and all hoses, all clear.No error codes when it stops, it just shuts off. Ran diagnostics and got a d9 and d18? Is it my motor control board?And if so, why would it go after only 2.5 years???
Re: My 2.5 year old Bosch Nexxtg 500 WFMC3301/UC washing...
Sounds like heater fault this will terminate program if no heat detected after a short time, hard water will make it worse unless you use a water softening agent.2.5 years for this is not unusual.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
well if theres more water in it now then when you took clothes out , id fail to se how its a drain issue , no id lean towards the inlet solenoid valve have a small bit of debris keeping it from closing all the way , this will probably need replacing
You have a bad water supply valve which is struck in the on position-this valve is mounted inside the machine right where you attach the supply hoses-cheers Denny
If your washing machine will not fill, only hot or cold will fill or is slow tofill then read these tips. I have covered many of the things that can happen inthese tips...
If your washing machine will not fill, only hot or cold will fill or is slow to
fill then read these tips. I have covered many of the things that can happen in
these tips…
Timed out on drain cycle, basically you either have an outlet blockage or something is trapped in the pump, you can check the pump by opening the bottom right flap on the front panel,manually emptying the w/m and checking the pump filter for coins etc. Also, check the outlet isn't blocked. Good Luck.
I solved this problem very easily I noticed that the bag was full of lint and was holding back the water that was draining from the machine.
I guess the machine could not complete a full cycle to finish where the door would open automatically
×