Whirlpool Gold Ultra Care 2 Dryer

The first thing you need to check is if you actually have 240 Volts going into the dryer. Sometimes one half of the (dual) circuit breaker opens and only sends 120 Volts down the line. If you hear a buzzing sound when you press "start" but nothing happens, it could be a stuck motor. Or the motor could be running but the belt is broke. There are more possible scenarios, but try this first.

Sounds like a faulty transmission. Also, make sure this machine is not sitting in a cold environment. If it is...run a blow dryer under it for awhile and try again. But really I think the transmission is gone.


Aaron

belt come off or cut. :(

it could be your heating element but if you use dryer sheets take your lint trap out and see how well water will run thru it it may need to be washed in hot soapy water hope this helps

I would suggest the coils on the gas valve . Also check the vent to make sure good air flow is getting out of the dryer . Try disconnecting the vent hose and drying a load to determine if maybe the vent is the problem .

coil starts and then cools down

That has to be a stopped up vent or a lint filled dryer. You gotta clean out the lint, open the vent.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

the heater box fuse has failed,most likely from a clogged vent on the back of dryer or wall,you can remove the large back panel to get to the fuse it is on the top of the heater box on the side,it is a small fuse,you can get one at sears .com click on parts put your model number in(inside dryer door)and get your part,let me know how you do-mike

You may be having a venting issue, disconnect the vent from the back of the dryer,if it drys normally then you have a clog in the vent line too the outside, if still takes too long too dry you may have a bad operating thermostat on the blower housing.

the top and the front has to come off