My dcc2725 shows replace yellow catridge, i put a new one, it give the same error, i put the toner in another machine, it is working what can i do?

SOURCE: MFC 7420 always say toner low after you change new toner

1. Open the front cover door.
2. Press the "Options" button.
3. Type *00 on the keypad.
This will clear the error message.
Enjoy!

SOURCE: MFC 8460N giving Toner Life End message

I just solved my own problem. Try it for yours. I had been using several compatible toners for the MFC-8460N with no problems until today, as I posted earlier. On a hunch, I went to the local office supply store and purchased one original Brothers TN550 toner and put it into the printer and closed the cover. Everything clicked. Toner End Life message gone. I then took that Brother toner out and put the compatible one back in and still everything was fine. Am keeping the original Brother toner as a "kickstarter" if it happens again.

SOURCE: change toner error brother 2820 mach has new brother toner ctg

with machine on, open front cover, press the "options" button, you should see "replace drum?" press the "start" key then 1 then 0. display should show accepted for a couple of secs. then show cover open. close front cover and message should be gone. if not, you will have to contact Brother.

hth,
razors

SOURCE: Xerox Phaser 6180MFP i have replaced toners

Supposedly the 6180MFP allows the user to select a non-genuine mode (select "Non-Xerox Toner" on the maintenance menu). This option is listed on page 9-18 of the User Guide, and I think it's the same as the Non-Genuine mode described on page 1-38 of the Service Manual. However, when I actually look for this option on my printer it doesn't appear to be present. Maybe Xerox removed it and didn't update the documentation? Anyone else know about this setting?

abbas rezazadeh

• 328 Answers
• Posted on Jun 10, 2010

SOURCE: MFP sharp ar-m420u/mx-2300g new installation.

Change IC connector on toner unit with two screws neer gears of toner cartridge.