Question about Kettler Sport & Outdoor - Others
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
This is a common problem for the CTR1, it actually sounds a lot worse than it is. It's just one of the 4 bolts that hold the front "pole" of the CTR1 in place that is broken. You will need to unscrew the bolts at the base (just move the plastic piece that hides the bolts up on the "pole"). After removing the pole you will need to remove the broken bolt from the inside of the "pole" with plyers. Then just put the pole back in the base, replace the screws (be sure to tighten them good). All will be good :)
This is a weak point of the CTR1, be prepared to run into the same problem again down the road...
Posted on Jan 16, 2011
SOURCE: how to access batter on
If you look behind the unit, (directly behind the digital readout) you'll see a small rectangular inset, if you look up in that (I used my cell phone light), you'll see a tab that you can pry with a screwdriver gently to release the computer section. Just keep one hand on top, when you pry it you'll feel the unit pop up, then you can lift it out. It takes 2 AA batteries, thankfully not some bizarre disk batteries :)
Btw when you look at the readout, you'll notice it's set in a silver square- that square is the computer module that pops out.
Hope this helps!
Posted on Feb 21, 2011
Posted on Oct 28, 2014
Tips for a great answer:
Jun 28, 2015 | Kettler UNIX PX Elliptical Cross Trainer
Mar 09, 2015 | Kettler Sport & Outdoor - Others
Feb 24, 2015 | Kettler Verso 309 Elliptical Cross Trainer
Oct 28, 2014 | Exercise & Fitness
Feb 25, 2014 | Kettler Ergo Racer GT Indoor Cycling Bike
Sep 15, 2010 | Kettler Mondeo Elliptical Trainer
Dec 15, 2008 | Kettler Mondeo Elliptical Trainer
Dec 08, 2008 | Kettler Mondeo Elliptical Trainer
25 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: