Sounds like you will have to remove the kitchen door it self by taking out the hindges on the side with a screw driver and hammer just put a nail or screw driver in the hole and punch it up and out
Testimonial: "Thank you for taking the time to answer. Unfortunately even with the fridge's door AND the kitchen door removed, the fridge is way too large (about 1 inch). It came in through the window about 25 years ago but it cost a bunch to take it out the same route. I finally resolved myself to cut about 4 inches off the fridge's front. Actually not too difficult to do. The only thing you need to take care of is not cut the small pipe that goes around the front. After cutting and removing the outside metal shell, you need to dig inside the polystyrene, uncover the pipe and fold it back inside the fridge before completing the cut of the inner plastic layer."
SOURCE: removing doors from a samsung rsg 5 dumh american fridge freezer
doors are removable. wiring to the door is plug and socket
SOURCE: hotpoint fridge freezer / howdens kitchen - no instructions!!
Luckily the hotpoint helpdesk admitted that the instructions for hanging the kitchen doors does not come as part of the standard instructions. There should be a seperate piece of paper with these instructions.
After some to'ing and fro'ing they managed to email me the required diagram.
SOURCE: Kitchen Aid Fridge KSRF25FRBL00 - Hot Panel between doors
This strip is warmed to prevent condensation forming here during humid weather. Some models use a refrigerant pass of the compressor to warm this strip other use a heater that can be controlled by a 2 position switch in the refrigerator control panel that reads something like "Turn this on if moisture appears on cabinet exterior". If you have no such switch you should be aware that the strip is ALWAYS warm but barely noticeable until you develop a problem in the cooling system.
Check temperatures in the freezer (Zero Degrees approx.) and refrigerator (Approx. 30). If these are normal don't worry about the heat from that strip. If you find a temperature not normal you have the beginning of a cooling problem unrelated to that strip.
136 views
Usually answered in minutes!
×