Typically the LOOP terminal is an iinsulated connection point of a load device used to extend the ACTIVE to the switch device (a switch loop).
As the switches are incorporated within the load device theres no need for a LOOP terminal.
It could be you have selected a device that is not best suited for your application.
Load it the light, fan, motor, etc that consumes power
http://waterheatertimer.org/Electrical-terminology.html
http://waterheatertimer.org/Safe-electric-wiring.html
Typically, 120 volt incoming hot line is connected to black, white to neutral, ground to green...
Then load has 2 wires + ground ... the white connects to neutral, black connects to load wire, and ground to ground
SOURCE: in house wiring i know that the green/yellow wire
The standards red
is hot black or white cold and green is ground, however every house been wired
by someone other than you and for that you need top make sure that it is not
connected reversed. Remember Always “Safe than Sorry”… Let me know if that work for you and please
do not forget to rate my service so I can keep providing this service to everyone
and improve on it. God bless
SOURCE: Following the purchase of a new home I want to
please remember to turn the power off when you are doing this. the extra cable is probably a looped or joined cable. put it in a connector or solder it with tape and leave it behind the light fitting or in the terminal block. connect the same cables up in the active, neutral and earth. like for like. make certain the power is off when you do this.
SOURCE: connecting old electrical cord to new spa motor
This is good information to have on hand. thank you for posting this.
any other issues with the spa motor?
RodUS Parts Center888-521-6813
130 views
Usually answered in minutes!
×