I need help with fixing my Victory 10 mobility Scooter seat from swiveling

SOURCE: Pride victory mobility scooter

1. Remove the four screws on the outside perimeter of the console base.
2. Lift off console top cover and disconnect the front-to-back cable.
3. Remove the throttle lever from the throttle pot.
Remove the four screws holding the console base to the mounting plate.

SOURCE: THE SCOOTER MAKES A HIGH PITCH NOISE WHEN THE KEY IS TURNED ON

The buzzer is a piezo-electric device that is the "horn" for the scooter. It also will alert when the scooter is in reverse, if this option is programmed into the scooter. It receives its power from the PC board or console board which is located inside the top of the shroud at the tiller, where the thumb paddles that direct the scooter are located. If liquids have reached the board, or if condensation has affected the board, the circuit that controls the buzzer may have shorted causing it to come on constantly.

Opening the top of the shroud is fairly simple. Remove about 6 screws holding the clamshell cover together, remove the speed adjust knob, and it should come apart. Inside you'll see a PC (printed circuit) board, green in color with lots of small electronic parts embedded on it. The buzzer is also inside, usually about the size of a marshmallow and black in color with tiny holes to let the noise escape. There will be two wires leading from the buzzer to the plug-in at the PC board. Unplug the buzzer and the noise will stop, but you won't have use of the "horn" at all. Replacing the PC board can be done by a certified Pride tech, but it will probably cost you about $150.00 for parts and labor.

Hope this helps.

SOURCE: I have no manual for my Pride victory mobility scooter

http://www.pridemobility.com/pdf/owners_manuals/US_Scooter/US_Victory_10_om.pdf

Click on this link and a pdf manual for a Victory 10 will appear.

Rob Hill

• 1480 Answers
• Posted on Feb 19, 2010

SOURCE: Replacing the battery on a mobility scooter

hi, ok remove the seat by turning it to the left, there is a lever normally on the right side that will allow it be turned round,

once you done that, lift the seat in a upwards motion, the cover should come away by gemerally lifting it, it should be attached by velco underneath,

you should now see two batteries. 40Ah batteries will allow you to go further if the battery Ah is lower, 50ah batteries again will allow you can go even further NOT faster, if you buy the larger AH batteries please make sure the dimensions of the batteries will fit within the scooter battery holders.

Regards
GeWiz.

Testimonial: "Thanks so much for the help. The seat did come off in the end but with difficulty. Batteries now changed OK. Thanks again. "

SOURCE: I have no manual for my Pride Victory 4 wheel

Hello i hope u 'll be fine.... thanks for using fixya.

You can easily get the manual for Pride Victory 4

• To download just Click Here

• Manual is in pdf format if you have no Adobe Reader software which support pdf files then Download it from here Adobe Reader