Health & Beauty Logo

Related Topics:

J
Jim Rowe Posted on Oct 20, 2019
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Turn on key power lite on dash lite press throttle forward or backward lite start flashing and scotter not move

1 Answer

Rob Hill

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Health & Beauty Master 1,480 Answers
  • Posted on Oct 21, 2019
Rob Hill
Health & Beauty Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Jun 13, 2009
Answers
1480
Questions
0
Helped
517999
Points
3838

Hi, how many flashes before a pause ? that's the controller telling you what the fault is ..

Regards

5 Related Answers

Anonymous

  • 10 Answers
  • Posted on Jun 20, 2009

SOURCE: power seat issue

Get out your voltmeter, unplug the connection to the seat's motor, underneath the seat, and hit the switch. if youve got power going to the motor then youll need to replace the motor. If not, it's probably the switch. Also make sure the wires are not cut or damaged somewhere between the switch and the seat.

Ad

Jonah Oneal

  • 14092 Answers
  • Posted on Dec 13, 2009

SOURCE: Driver's power seat will not move backward

check fuse.if fuse is good check for power at seat motor.if yes replace seat motor.if no check wires at switch.if wires is not loose or broken seat motor switch could be bad.

Anonymous

  • 1 Answer
  • Posted on Jun 21, 2010

SOURCE: will not move

The transmission is shot. A common problem. Mine died after 3 years and 200 hours of use. Estimate to fix was almost $2000. I scapped it and bought a better mower. There was a rtransmission design defect in the RZT series.

Anonymous

  • 5 Answers
  • Posted on Aug 05, 2010

SOURCE: My 07 street glide won't start.when i turn the key

Turn the handlebars to the left and lock them with the key. Once locked, unlock and try to restart, this resets the alarm on my 2008 FLHX.

Anonymous

  • 2 Answers
  • Posted on Aug 19, 2010

SOURCE: power seat won't move backwards

I had the same problem some one on one of the web-sites solved his problem by banging on the track rail in the front while pushing the seat button back after a good few bangs it unjamed and works great now .I feel like I saved at least $1500 by dealer rates.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Need some help w/ 1998 Yamaha BIG BEAR 350 2WD.

It's designed to only start in neutral. If the reverse light is on, it will not start with the button.
1helpful
1answer

Aquasoothe lite forward/backward reversed

Hi, you need to expose the throttle pot that is the pot attached to the lever you move to go forward or backwards, normally it a top cover known as the tiller cover, once you done that you see the throttle pot has three legs with coloured wires attached now you need to crossover the outside wires, not the centre one, by doing this you're are moving the reserve to the right hand side and the forward to the left hand side.

if you require more assistance then please let me know..

that's it,
regards
0helpful
2answers

I need help with my scotter you turn the key and the lite keeps flashing you turn the key the battery is charged but the lil green light keeps flashing

It could be many things. If you just bought the scooter, it could be a loose wire in the electrical system. Did you check the battery terminals to make sure they are tight?
1helpful
1answer

Scooter, when key is turned on the scotter jumps forward, the thottle is not in use, and the scooter is NOT IN GEAR, scarry

Your scooter may have lost its inhibit resistor 10k resistor that some scooters had on the center post of the throttle pot to stop this from happening. but the throttle has to be out of neutral position in order for it to move on startup. The throttle pots are normally 5k ohm pot, about 2.5k from the center to either outside posts. It would be wise to replace the speed control and the throttle together. Basically the controller thinks it is being told to go right at start up, that comes from the throttle.

I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489

0helpful
2answers

The error lite on Buzzaround Lite scooter flashing

5 flash code is the electro magnetic Brake. This is referring to the brake on the motor that can be released by the freewheel lever.

1. place the freewheel lever into the free wheel position. Ensure the scooter is in free wheel and move the scooter forwards and backwards a few times.

2. Place the freewheel lever in drive position, push on scooter to ensure it is in drive and does not move. Turn on key and press the throttle. If you have the same code again, call a technician to check the brake, chances are it needs replaced.
1helpful
1answer
0helpful
1answer

Older Shoprider 778b goes backwards when key is turned on, what's up? Check all connections.

The throttle set screw may have slipped a bit causing it to be a little bit on so when you turn the key on it moves forwards or backwards loosen and reset throttle bar and it should stop doing this.hope this helps Richard
5helpful
2answers

Right out of the box yiboo uj 381 r/c helicopter. Copter charged and new batteries in the controller. Lights flash on the copter and flashing light on the controller but nothing happens. what's wrong

did you turn the radio on first. It must be powered up with the throttle stick at minimum. Turn power on and then move stick to maximum and back to minimum. The remote lite should stop flashing and then power on helicopter.
Dec 25, 2010 • Toys
35helpful
1answer

CHANGE THE TIME ON MY PANASONIC 7453

To set date and time on your phone system you must first enter user programming mode.
Using a display phone with the receiver hung up.
Press PROGRAM
Dial ** 1234 (SYS PROG NO)
Dial 000 (DATE AND TIME)
Press SP-PHONE key once (display shows current date)
Normally this is correct if not dial the changes in with your keypad. Use the FWD\DND key to
move forward on the display and the CONF key to move backwards.
Press AUTO DIAL STORE (Confirmation tone)
Press SP-PHONE key once (display shows current time flashing on hour)
Dial new hour (Two digits) Use the FWD\DND key to move forward on the display and the
CONF key to move backwards. Dial in any changes and when your done:
Press AUTO DIAL STORE (Confirmation tone)
Press HOLD (SYS PROG NO)
Press PROGRAM
Your phone should be back to normal.
39helpful
1answer

Setting the clock on my baby g shock watch

Press & hold the adjust button until the time starts to flash.

Press mode button to select hours.

Press forward or reverse button to move hour backward or forward.

Press mode button to select minutes.

Press forward or reverse button to move minutes backward or forward.

Repeat the process for the month/dte/dy/yr

Press adjust again when finished
Mar 09, 2008 • Watches
Not finding what you are looking for?

259 views

Ask a Question

Usually answered in minutes!

Top Health & Beauty Experts

Rob Hill
Rob Hill

Level 3 Expert

1480 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66931 Answers

ADMIN Eric
ADMIN Eric

Level 3 Expert

39381 Answers

Are you a Health and Beauty Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...