After disconnecting the motor from the output terminal of keb f5 servo and start only the inverter the display error e.oc still occur.
Error over current.
This PDF explains it.
http://www.servotechnica.spb.ru/viewdocument/KEB_CD/manuals/f5/f5s/00f5subk250.pdf?page=33
SOURCE: F5 keb inverter problem
i have a prblem in the F5 keb combivert it's show Error
E.OC & E.puci & E.Puch could you please advice us with the proper solution
thanks
SOURCE: F5 KEB inverter nop problem
If using bus communications (Can, ProFi, Mod, ext), there may be a communications command (Software signal) that is not being provided. Hardware and software enable signal required to obtain LS.
Possible that the terminal on the control card is bad due to miss connection or signals outside of the rated value.
790 views
Usually answered in minutes!
×