My vac stopped working is there a reset button on a airspeed unlimited rewind vac

Ivan say for sure without knowing your model number but it most likely does not have a reset button. Most have a thermal reset belt into he motor because it's cheaper than putting on a reset button.

Arr you wanting to buy one of these belts?

That depends, is it just loud or is it loud from a vibrating noise? Does the machine shake? If not, then the machine is just loud unfortunately.

Worn brushs in electric motor, it is comon in
units used much, maybe a bad or burnt switch

Eureka AirSpeed MyVac Owner Manual How To Replace Brushroll Or Belt How To...


Eureka AirSpeed MyVac Owner Manual

116-...... usually indicates a Sears/ Kenmore model vac Please clarify

try pushing the cord back in whilst depressing the retract button

Not familiar with thi sbrand, but a reset is for when the brushes get jammed pr stalled, it will trip the reset. Make sure that the brsuh roll turns easily, also for a broken belt and/or bad brush roll. Some resets are for when the vac motor over heats, it will trip saving the motor. Usually this is for a jammed brush roll or a clog.

You have to pop the grey button off for the cord rewind. There is one more screw under there. You have to be very careful, because you can break one of the tabs that hold the button on. In fact, it is almost a garuntee. There are three tabs that stick off the button that hold it in place on the orange hood. There's a long tab about 3/4 inch long on the inside corner of the button you need to be careful of. Good luck!