Question about Maytag Washing Machines
Hi JR,you have a bad tub bearing. Replacing the tub bearing is a complex job as it requires dismantling the whole tub assembly and replacing the tub bearings and tub seal. I would recommend calling a local repair company to get an estimate for the repair. It may be more than the cost of a new machine. Hope that helps.
Posted on Jun 04, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
occurs due to belt slippage. I would check your belts (look for cracks.
Check the belt tension as well, most washers have an adjustment,
normally on the motor that allows you to increase the tension of the
If part of a belt gets torn and it is long enough, it will hit any part of the washing machine within range and make a clicking noise at every revolution of the motor.
I am pretty sure you need new belts. You should be able to remove a few screws and open the back cover. Between the pulleys there is a tensioner...loosen that so you can remove the belt easily. replace it with a new belt and adjust the tension.
hope this helps
Posted on Feb 23, 2008
very loud in spin cycle can mean a bad rear bearing, not something a homeowner would want to try to replace, parts would exceed 6-7 hundered dollars. you may have some extended part warr through the manufacture. still probly gonna be a 5 hundred when the labor is added in
Posted on Dec 06, 2008
Loks that your machine is pretty old and hence the belt has hardened making a squeaking noise.
Good fix is get a new drive belt.
Quick fix is you could put some oil on the drive belt..... it will work for now but not a permenant solution.
Posted on Feb 01, 2010
We have a Maytag Bravo Quiet Series 300 washing machine, the door latch is broken. I have the replacement part ( the locking mechanism) but I need can not figure out how to get the top of the washer to flip up to give me access to top front of the machine to remove the old part and replace it with the new.
How do I flip back the top (not the door) of this machine?
Posted on Jan 03, 2011
Tips for a great answer:
Dec 02, 2014 | Maytag Washing Machines
Nov 05, 2013 | Maytag Atlantis MAV6000 Top Load Washer
Dec 05, 2012 | Maytag Legacy Series Top Load Washer
Oct 15, 2012 | Maytag Bravos MVWB700V Top Load Washer
Sep 05, 2010 | Washing Machines
Jan 15, 2010 | Maytag Washing Machines
Dec 14, 2009 | Maytag Neptune MAH5500B Front Load Washer
Nov 27, 2009 | Maytag Legacy Series Top Load Washer
Jun 10, 2009 | Maytag Atlantis MAV6000 Top Load Washer
Jan 13, 2020 | Maytag Washing Machines
70 people viewed this question
Usually answered in minutes!