Question about Washing Machines
Posted by Anonymous on
Hi, try using a pair of slip joint pliers. Open them about half way then place one jaws on each side of the filter handle then slowly turn the filter to the left. The added leverage should make getting the filter open easier. Keep a couple of bath towels or a wet vac handy to catch any water that comes out. Hope that helps.
Posted on Jun 04, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: spinning cycle
Keeping in mind that the soap & bleach gets dispensed into your wash on the
second to last rinse cycle and that most all rinse cycles are in cold
water. Is your cold water valve screen plugged causing your washer to
rinse poorly? Are you using the HE detergent? If not maybe the
washer is sudsing up to much and having a hard time rinsing all the
suds and bleach out and leaving the clothes soapy.
Fill the washer up with no clothes in it on a cold/cold wash setting does it take a long time to fill the washer up? Also when it is full and agitating is there suds in the washer?
Last suggestion is if the drain is hose is a lot higher than the top of the washer it might have a hard time draining out all of the soap water before the next load
Posted on Mar 23, 2008
SOURCE: LG WD-8013F wont spin
I checked the lint filter at the front bottom left hand side and it was full of junk. Once emptied it worked a treat. Pull the flap down and turn the large knob anti-clockwise and pull to remove. Good luck.
Posted on Apr 22, 2008
The filter on this machine is behind the flat at bottom right of machine. Tilt machine back before unscrewing to avoid spillage. If filter is clear get back to me and will explore other possibilities.
Posted on Nov 16, 2008
I have an E2 error on the display of a homemaker washing machine model no HMWM8000. It will not pump out. The PCB does not have any visibly damaged components, which part is faulty, and how do i test a water level sensor.
Posted on Nov 08, 2009
Tips for a great answer:
Dec 09, 2017 | Washing Machines
May 19, 2012 | Bosch Washing Machines
Nov 01, 2009 | Maytag Neptune MAH5500B Front Load Washer
Oct 08, 2008 | LG Washing Machines
Apr 20, 2008 | Washing Machines
Dec 02, 2007 | Washing Machines
Nov 28, 2007 | Frigidaire ATF6000ES Front Load Washer
Nov 26, 2007 | Indesit W 123 Front Load Washer
Nov 25, 2007 | Washing Machines
May 17, 2007 | Frigidaire FGX831C Top Load Stacked Washer...
39 people viewed this question
Usually answered in minutes!