Stanley 1200 garage door opener. Which remote control works with the

SOURCE: Switch settings on stanley garage door opener

check the pin configuration on the back of the Stanley 3200

SOURCE: have chamberlain security plus 950cb lost instructions.

http://www.chamberlain-diy.com/doityourself/pdfdocs/114A2184.pdf
This web address came from the Chamberlain site. I also needed to relearn my remotes due to a newer car that has a built in garage door opener that needed to be set. I also needed to reset my keypad remote, those instructions I was able to get from the same site. Good Luck

SOURCE: Craftsman Model 139.53684 Security+ Keyless Entry

To answer your question the opener is in vacation mode. Press and hold for 3 seconds the button on your wall control with the lock icon. The green light will stop flashing and you will be back in business.

STEVE WOLFINBARGER

• 504 Answers
• Posted on May 26, 2010

SOURCE: Stanley garage door opener chain screw adjustment

THE ADJUSTMENT IS SUPPOSED TO HAVE A 2ND NUT THE TWO TIGHTEN AGAINST EACH OTHER AND ACT LIKE A LOCK

SOURCE: I progammed by accident my #1 button on my KLIK1U to my #2 garage door. Then I seen the mistake, so I programmed my #1 button to my #1 garage door. Now my #1 button controls both garage doors and I no

You're going to have to clear the memory on the openers. This is usually done by holding the learn button for about 15 seconds or until the led turns off. I'm not sure exactly what opener you have, so this may not be the case, if not, let me know exactly which opener you're programming your remote to.