What is the BEST cleaning product? I got the square boxing ring?

1897

Had the same problem. Instuctions show a different ring (smooth on one side, grooved on the other) they say to keep notches facing up. My ring had grooves on one side and large square notches on the other. Due to the way the ring is tapered, the round notches face down, opposite the instructions . And plate warmer fit better. Short answer: flip the ring over.

Back in the old timeswhen men used to have punching fights, the men would stand in a circle and joinit with a rope, this became the Boxing Ring. I guess the name just stuck

Possibly. Actually there are sub rings you can buy to convert a regular box over to one that will accept a square sub without cutting the whole out in your box to make it square. The airspace may be lacking a little bit.

The retro-ring 4x4 (#206 Raco) is intended for 4 square boxes. For a 3x2 box you should use Raco 977 box supports: http://www.grainger.com/Grainger/items/3XK12?Pid=search

If you have already committed, you can use a Raco 8787 (flat 4x4 cover):
http://www.hubbellcatalog.com/raco/RACO_datasheet.asp?PN=8787&FAM=RacoBoxes

Hi, there may be other "Questions" along the way that may need answering, one of the best information centers, is the (?HELP!), it is located on the Microsoft (WORD) Menu Bar; just look for the ("circled?"). ou can enter a question in the search (box), or go to: the "Table of contents" for a listing of most ask question etc. "I hope this helps' Ya"s

this shotgun has a gas blow back if you take off the barrel and pull out the blow back piston inside you should see two small gas ports clean them out with a steel pick to get out any carbon in them then clean the blow back piston and piston bore, dont over oil this part, but it must be realy clean and free to move look closly at the piston for any were in it if any gas is leaking past this piston the shotgun wont cycle unless you use realy fast and thumpy loads,
this make of shotgun never has liked light loads

your shotgun may just need a realy good clean up,,,look in the gas by pass ports in the barrel are they blocked up with crud! clean the piston and cylinder remove all the carbon use very light oil on this part,,strip the action to clean it out of unburnt powder,,,,also they dont like soft rounds,,stick to fast heavy loads,,they love them,, but birds hate them!!!

The cartridge stop is sticking and you should give the gun a good cleaning and see if that helps...

Thumb trigger safety not disengaging fully. have you cleaned lately?