When i power up the inverter Micromaster 440 the fault F0001 appears

F0022 - Hardware Monitoring Active (as Im sure you are aware)
This cannot be 'cleared' without a repair.
Likely several components internally need to be replaced.... if you can get them.
There are too many possibilities to list here and recommend you dont spend your time trying to repair it yourself. It may well be in vein!
Consider sending it for repair or service exchange.

Depends what you have digital output 1(terminals 19/20) programed as. Check P0731

This is most likely a fault with the IGBT even if it meters out correctly.
They can be replaced but the cause cause of the fault in the first place may still be present and might damage it again.
Occasionally there are further issues from faults like this so I would give some thought to doing a service exchange with a repair company.

Hi, this issue could be caused by a number of things from simple dirty connections internally to multiple component failure.

I am unaware of your competency level so am reluctant to advise component diagnosis given the potentially lethal voltages that you may encounter.

I would recommend a third party repair company take a look at it but new spares are pretty hard to source as are second user spares, so prepare yourself for it to be beyond economical repair.

Where abouts are you based?

This thread may help.....
https://www.automation.siemens.com/WW/forum/guests/PostShow.aspx?PageIndex=1&PostID=441795&Language=en

Likely to be IGBT fault. Unless its a large drive I would service exchange it or bin it. Not worth the hassle.

what a fault 001

jst chk out the connection of the plc and find that the resistence of 500 ohms linked with 10v which converts 10v to 4-20ma is working if it is then it will work or check the drive's connection n parameters of P1300 & communication parameters

may be the BOP is not correctly connected
or the supply provided for 2phase has to be interchanged

Why do you want to run the motor in the delta configuration? The VFD will change the speed to anything you want to do. The delta and Wye connections are normally used to change the speed of a motor. That's what the VFD is for...??

If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c