The treadmill power socket and lights are on but the dashboard is off. it doesn't work. what must i do?

Do you have the safety key in? Generally treadmills wont work without one plugged in.

That is not possible, if it shows power then there is no reason for it not to light, check the bulb with a meter, could be bad, then check ground

You can completely switch off the power for a few minutes and there is also a 'reboot' button at the front/bottom of the treadmill that needs to be pushed for about 5 sec (check manual). In my case that did not work and I had to replace the complete control panel/dashboard. My problem was different, I got funny messages about errors and flashing numbers on the dashboard. Tunturi was helpful in getting me the necessary spare parts. Good luck.

rese the treadmill and try again.
if the problem persist go to the MENU, and turn OFF .

God bless yo

take a test light and make certain your getting power to the socket. could be a bad socket

Take a test light, you can buy at any parts store, connect the roach-clip to a metal surface of the vehicle, poke straight down into the center and contact the center electrode. If the test light lights up, then you may have a problem with the ground (outer metal part of the socket). To test this, find another power source in the fuse block. Hook the roach-clip to the power source. Now, poke the outer round housing with the test light. If it lights, the ground is good. At this point, if all is well, then your charger for your phone is toast. If there is no power, or ground, the connector on the back of the socket may have fallen off.

hi, please check communication cable from speed controller to console

The vibration of the move may have loosen the connectors. Unplug unit remove motor shroud you will see the motor control board pull and reconnect all connections also check the connector in upper electronics then on unit see your display works and see if you have motor and belt movement.

HI, make sure there isn't a short in the actual outlet wall socket. if the outlet wall socket is in good condition, this will confirm power board failuer.

You will need to replace the power supply board in this unit in this case.

There is a breaker in your circuit box it is silver mine did the same thing and i had a loose wire on my head light switch and my breaker was blown...