At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Is the the flour? Have you tried different recipes and does the same thing happen? Too much salt can prevent rising, or not using rapid rising yeast. good luck.
Hey, I really think you should have mentioned the brand of treadmill but however all the treadmill i encountered all function on the same principles... though some may seem more of a hassle to do they are all the same (correct me if i'm wrong)... So with that being said you would need to remove the motor housing cover by removing all the screws around the sides and front of the machine. By now you should have a clear view of the front roller, on one side you should the the belt driven pulley that is held on by the belt alone so removing that along with the bolt on the opposite side should do the trick.... lemme know if this helped
Please RUN the software calibration for easy diagnose and troubleshooting. However Lube the elevation motor+shaft+gear+pinion+adjust the small POTENtiometer a little. see the diagram attached and proceedGod bless you
1) lube the motor elevation, shaft +gear and adjust the POTentiometer a little 2) see the diagram attached, 3) Run the software calibration for troubleshooting, 4)test the relais for open or faulty coil,and clean the contacts very well God bless you
hi,
Its time to lubricate your treadmill.
You must obtain the proper lubricant for your treadmill. There are several different types. Contact your manufacturer for what type is needed. Using the manufacturer provided allen wrench, loosen the walking belt approximately 10 full turns on each side of the rear roller. Apply approximately 1/2 ounce of lubricant directly in the middle of the walk area underneath the walking belt upon the deck.
Retighten the rear roller 10 turns on each side. Run the treadmill at 6.0 mph for 2-3 minutes to spread the lubricant evenly. Wipe excess lube from the sides of the belt. Walk on treadmill to check for proper tension on belt.
for make it easy for you I have added a video.
ok
With the key in the console, press one of the incline buttons. While the incline is changing, remove the key. After a few seconds reinsert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level. Thi will recalibrate the incline system.
Observe as the main motor controller board has 90% of functions of the any treadmills. Now you will have powerful resultant and determine what is wrong.
×