Hi THANKS A LOT FOR THE HINT WITH A RESET OF MY BLINK COMPUTER: Now it works perfectly! Niels Denmark

Its not a thing may heppend by playing only (but is possible) it may be dropped on the ground or something like this and display commection to main board has troubled (some connections is disabled) ans when display receiving damagd signal it shows up incorrect picture. sometimes may correct picture but better way is to take it to customer care, because phones don't have such functions and correction by yourself is quite difficult bussiness.

Hi,

Thanks, I picked up a hint about Degaussing on your site and it worked perfectly

Greg

Tip washing machine towards you, water in bottom of machine will pour out, so be ready! Should work after that, mine did!

Hi!

You can download the free drivers for your SiPix StyleCam Blink Digital Camera from the following link--

Drivers

Thanks for using FixYa and do rate the solution as Fixya if found helpful.

Thanks
Rylee

Hi there,

Here in Denmark, lots of people are well tired of this router.
It often loose internet connection, but a hard-reset fix the problem most times.
Maybe you just have to unplug the power for a few seconds and then plug it back in, - wait for a minute or two until all the lights are on.
If this doesn’t work, please respond, and well find another solution.

/Teis

i suggest you use energizer e2 lithium batteries is has long time run with digital cameras and is good for fast camera shooting. 10-year shelf life...you would be able to save a lot with this batt.

In my experience the diffusion issue can be intermittent and also only be visible on some scenes or even different inputs. If the service center did not see them and did not perform the alignment as put forth by LG then most likely the problem still exists and you will see the dots again.

I am not sure of the models but on the rack mount Edgeforce product your suppose to hold the reset pin while powering up until the Alarm light turns on, take 2-3 mins. Default user/password is admin/admin.

Fair warning I have one that is locked right now as well and a reset is not resetting and I can no longer log into it either. Anyone with ideas?

See my other post. its very easy to replace the mechanism. Theres a printboard that seems to be hard to remove, but beware, you only need to remove the screews that holds the brassboard, and all the cables. Then You have acces to the Mec, wich only needs four screews to remove and thats it. Should only need half an our or so.

Good luck. Niels Peter - Denmark

PS Actually You can disable the automatic standby. Read the manual, cant remember the procedure.

The problem is the laser. For $13 you've got the best CD player on the planet.