Broken spring in spring action scooper need replacement

Model number and pictures please

You can find replacement springs for anything at any hardware store. The heavy duty spring on my sisters recliner broke and the chair would not stay down. I found the original spring laying under the chair with the hook broke off one end. She went to a local hardware store and they had springs that were the right length and proper pull weight, got one and brought it home. I turned the chair over, opened it up and put the spring on, closed the chair up and set it upright and it works perfectly. So don't tell me you can't find a spring to fix your little scooper. Go to the hardware store.

I suggest you get one of those manuals people get nowadays to do it yourself.. My nephew use it to repair my car and it's totally repaired now. Here's the website he bought it from. www.reliable-store.com

There's a spring in the switch to give it "snap action" on or off. The spring may be broken or out of place. They are not repairable, need new one.

According to me it\'s better to buy any pooper scooper. Depending on any service center may charge you high and you have to wait for them till they arrives for cleaning. If you buy any efficient pooper scooper for dog you can dispose waste without handling with your hand and it will be much easier.

Broken spring.

I assume you can get it assembled, but you aren't getting the right recoil action. Before you put the end of the rope through the hole to put a handle on it, you need to preload the spring a bit by turning the spool 3 to 5 turns in the direction that would push the rope out through the hole. As you do this you will be winding up the spring. Then put the rope through the hole and put the handle on it.

There is A Spring or Spring type Mechanism At the Door that POPS the Door Open Once the Button has been Pushed . And when you Close the Door This Same SPRING ACTION Sorta Fights Against your Closing it. Well it Sounds to me as if this Spring Action is Not Working Properly,
Take a CLOSE Look at this and Be sure This is Working Properly, My References Do NOT Go into DETAIL on this so its Kinda a Common Sense Approach to it.

Max nailers are very good quality and parts are not expensive. Parts and parts list at www.toolpartsdirect.com. Check the following to repair not feeding problem.
Check paw in the door should have a light spring action. Feed paw should have a medium spring action. You may have to pull the feed piston back and hold to check feed paw spring action. Feed piston should have heavy spring action. If springs seem ok then remove feed piston and replace two orings. If the feed piston spring is broken replace with correct part. Make sure that the ports that direct air to feed piston are not blocked with bits of rubber or dirt. Sometimes parts of the bumper will break off and spread thru-out the gun. Good Luck and enjoy. (parts not expensive)