SOURCE: New wired Heath/Zenith doorbell buzzes until disconnected
it sounds like you have a bad push button . if the wires where crossed you would most likely have this problem as soon as you turned on power .
SOURCE: 03 Trailblazer Blower Resistor connector different
the resistor you bought is for manual heating, your three wire is more a module then a resistor. you need the module for the automatic heating system, automatic heating has a digital display and manual has sliders.
SOURCE: i have a newer radio and want to install it, but
use a volt-meter or test light to find the positive supply power from your vehicles wires, and the ground wire too. attach those to the new radio's power wires (and attach the new radio's ignition power wire, or switching wire to the positive power wire from your vehicle too). The point will be to get power to the new radio so that you can do a trial by error to find which speakers turn on when you connect them. Just follow the sound! after you have found all the speaker wires. the last thing is to find which wire from your vehicle needs to be attached to the ignition wire on your radio. This wire makes sure your radio is off when your keys are turned off so not to drain the battery. if you cannot find a switching ignition wire, run a wire to a connection in the back of a fuse panel connection (which you can test any connection with your volt meter to see if it shuts off with the key.
SOURCE: Cooling fan rubbed into wiring harness breaking 6
If they are taped they shouldnt have moved far from where they need to be if they arnt it should be easy to trace them back and get them where they need to go.
Check the speakers connection and that should give you at least 8 of the colors. The ones left then are going to be ground and power and display power. You can figure those out with a meter.
208 views
Usually answered in minutes!
×