How to fix bosch washing machine error code f67

SOURCE: bosch washing machine error code

I've had the same problem, when we had a power cut I opened the door and after that I could only got F21 flashing! ,I googled for the answer and this WORKED:
Turn programme switch to 6 o clock,hold RPM button turn switch to spin, release RPM button

SOURCE: bosch wae24363 washing machine, coming up with f17 error code please help

I had this same message last week. It is to do with the water intake (i.e. the water coming in to the back of the machine). If you have checked that the hose isn't trapped or kinked, unscrewed it and checked the filters at each end for blockages (rinse out if necessary), and you still get the F17 message, it may be because your water pressure is too low, in which case you need to contact your landlord (if you rent) or thames water if the problem is external (especially if there are any works going on near your house). Hope this helps!

SOURCE: sud message Bosch washing machine

ur using too much soap rinse and spin and use less soapwhen u wash

Testimonial: "thanks-- how do you know how much soap is enough?"

SOURCE: My Bosch washing machine (logixx

F37 is because of operating the unit below specified temperatures.

Pressing the temperature button twice shows a snowflake and sets a defrost function.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

Michael Thomas

• 3056 Answers
• Posted on Mar 07, 2011

SOURCE: I have an error code

Hello there
Normally this is a drainage problem code
Unplug the machine and wait for 30 min
During this time Remove the cover on the front bottom right corner or the front cover at the bottom , use the small hose that is attached to the pump to drain the water, from the pump then unscrew the large drain cover and remove the blockage from the drain pump. and any additional hoses then reattach the hoses and then plug in after the 30 minutes is up then press the cancel button and test ...Test by pouring 1L water into section II in the top and setting the machine to 'drain'. it should beging to drain