What does error code f11 mean on kenmore electric range model# 79095049700

The problem could be a damaged temperature sensor or loose wire to the temperature control F11 is the error for the control board keyboard being shorted out. replace the control board and keypad. ... The F30 error code means the temperature sensor probe is open.

if its a Kenmore model then this message says that the button control board has lost sight of the main control board , but its been my experience that this maybe able to be reset and it may never come back or it will not reset and the control board will need replaced (50/50)


cycling power may reset this

On a Kenmore it's:
F10 error code indicates a runaway oven temperature
Check this:
What does the F10 Error code mean on my Kenmore Electric range model...

What does the F10 Error code mean on my Kenmore Electric range model...

What is the complete model number of your unit?

F11 = control board failure
The power surge during the outage damaged the control board and it will need to be replaced. Here is the board to order.

The "F11" fault code indicates a shorted button on the electronic oven control. This means the oven control board will likely need to be removed and replaced. You could disconnect power, wait 30 seconds and reapply power. If "F11" returns upon power-up, replace the electronic oven control board (EOC). but if i had your model number i could nail it right on the head with a fix...

Hello, welcome to FixYa.

I understand you have the Kenmore 7904671 range, correct ? I also understand based on your post you're getting the F11 error message, correct ?
This range is built by Electrolux/Frigidaire as you may or may not know and according to the service manual, here's what it is and what you can do
...I will also add, Fault codes are not a foolproof system. Never assume that a part has failed based on a displayed fault code.


("TST" is the touch sensitive panel and EOC is for Electronic oven control or timer)
...If you pull/slide the unit away from the wall and unplug it or turn the house breaker off for 30 seconds to a minute the control should reset. That should do it...unless either of the control's has failed.
Let me know how you make out and if you need anything further I'll be glad to help in any manner I can. Good luck.
Regards,
Macmarkus :)

Your F11 error code is displayed below. It would be best to have the unit serviced by a professional for this type of fix as if not performed properly, the fix could end up costing over $500.00.

F11 Shorted Keypad.

1. (F11, 12 & 13) Disconnect power, wait 30 seconds and reapply power.
2. (F11, 12 & 13) If fault returns upon power-up, replace EOC.

EOC = Electric Oven Controller

what's the full model number?

This is not a known error code.
Please re-check and re-post.

Thanks!!