1 year old Kenmore Elite Trio Refridgerator not cooling

The tubing inside the door is most likely frozen. Mine did that a year ago. I had to remove gasket and loosen screws around edge and allow to defrost inside door. There was a lot of ice around dispenser and tubing.

There is two allen set screws for each hand at both end and they are facing each other on the handles.. Remove the allen screw and put a very minute speck of jelly on each screw---small-small amount. This will kept the set screws from loosen up. GB...stewbison

Check for cracks in the water supply tube from the house plumbing valve to the ice maker. Could also be the valve itself.

Turn off valve for a day to diagnose which.

I received my Elite TRIO 795.7101 2 weeks ago. I have ran over 3 gallons of water though it. I am still getting a bad odor and taste when I dispenser water from the door.

could be anumber of things happing, is the freezer fan spinning? if not ice will accumulate( also hamper cooling in the refrig section). perhaps a defrost issue, a bad heater or defrost thermostat could also cause, this/ may even just be the door being left open for extendedperiods of time( ie.. overnight, or hte gasket not sealing correctly) leading to a frost build up on rear panel

check the over-load/contactor on the side of the compressor,remove it and shake it if it rattles,replace it

If you see frost on the back wall inside the freezer , then your condensor is working , which indicates you have a defrost problem .

you have to flush dispense water on till taste gone

you have to give me model# so i can help you

I just went through this with my refridgerator and actually posted one of the questions. Here is what I found ........

In the freezer compartment behind the panel there is an evaporator fan which pulls cold air from the freezer and pushes it up into the refrridgerator compartment. If the fan is not working it is one of three things.. 1) there is so much frost in the fan area the fan blade is stopped and cannot push the cold air into the refridgerator compartment or the air channel is blocked. 2) there is no electricity going to the fan (usually tied to the door switch of the refirdgerator compartment, and 3) the motor is dead and will have to be replaced.

Solution to #1 - defrost but there is another problem in the "frost-free" part of the system which must be addressed or the frost will return and it will happen again in the future.

Solution #2 - check to see there is power to the fan. (most are 110VAC but some are 100VDC. Use a meter and check)

Solution #3 - If there is power, the motor is dead. Replace the motor. Be aware that AC and DC motors are different and replace per manufacture's specifications.