Ps410 bolt will not go up or down allso mag willnot rowtate

Check the breach plug, bolt retaining screw and scope mount screws if they are present. You may need to use a plastic mallet and gun oil like clp

Griffin and Howe were out of business before the 300 win mag was introduced.

It willnot work, You have to have the same brand of changer as your (Deck) Allso the deck has to be equiped that you can hook up a changer to it,

If you have the vollume control set around 40, End watching a movie if there is a loud burst in vollume,It is causeing the reciever to run over it,s wattage rateing. End over heating,When it,s shuts down, It went into what is called the protection mode.Keep it at a lower vollume then it willnot do that.Allso what can cause it to do that, If you have your output leval control on your sub turn right up.

Are you talking about a full magazine? You have to get the bolt out of the way because it is too tight? Take out 1 round and see what happens. Does it do it to an empty mag? You are not talking about a stripper clip are you? You know they don't come with magazines, the 30 rnd mags you get that are detachable have been modified some how. And they don't go in easy. Not like an AK, Let me know.

disk drive is broken. did you try laying it down to play? if you did and still the same its time for a new disk drive. sorry hope this helps. they can show how to fix it on youtube.

if diesel most probably air in fuel system,first check all fuel hoses for tightness ,if you can twist any hoses by finger pressure tighten.allso replace any damaged fuel lines ,check all bolts on the injectors for loose play ,allso check fuel tank breather for blockage does it improve with fuel cap cracked open.do not drive on the road like this !!.Finaly check your lift pump which fail quite often.Have you checked your fuel filter for dirt if black or dark replace.

don't e-mail me again YOU ARE to expensive for the time spent finding the solution

Try putting the original magazine back in.The tapco mag probably does not have the vertical extension that holds the bolt open.Compare the two mags side by side.Good Luck

AFTER SOAKING SEVERAL TIMES WITH A CAN OF "KNOCK IT LOOSE" or something better than WD, then

• Disconnect the wiring harness.
• Unbolt the sensor mounting bolt.