My ir3045 machine error code 733 How to recover it

Please feel free to contact our customer service number +1-(845)-477-5334 to fix all canon product related issues

Said to be a door jamming code. May need to pay a technician to repair, instead of attempting a do it yourself repair.

http://www.copytechnet.com/forums/canon/21295-jam-code-0b00-canon-ir3045.html

Hi Nikki, Is it 5e OR e5.... The link below is a samsung washing machine error code list, I hope this helps............CHEERS..
Samsung Washing Machine Error Fault Codes

Dear
(E 733-0001)(There is an error in the communication with the printer-
There is a DDI-P communication error.)

Pl. do.
1. Check the connection with the
printer.
2. Check the power supply of the
printer (to see if initialization takes
place at startup).
3. Replace the DC controller or the
main board.

Thanks.

Dear
The fixing film rotates in an abnormal way.The reading of the main thermistor is in excess of 100 deg C with the fixing motor in a locked state and, in addition, the machine fails to detect the marker signal.
check the sleeve and main drive assy.
Thanks.

Try to clear that error from service mode
press additional function
2 and 8 together
press additional function
select copier
select function
select clear
select ERR
select ok. Unplug of the machine for 5 second and then turn it back on
try to make some copies, if problem persists fixing heater is damaged and need to be replaced

the error no 733-0001

that error indicates a malfunction in the developing unit, probably a toner sensor is defective

Error 733 is a communication error between the reader (scanner) and the DC controller board. This code usually occurs when the cable that joins these two units has come loose. Shut down the copier unplug the cables and re-attach them ensuring there are secure. Turning the machine back on should clear this problem up. Should this not clear the issue, seek a Canon trained tech to trouble shoot controller board. Good Luck

is there a reset on washer,,just replaced water pump,,it will not complete end cycle high spin,,belt is fine ,motor is fine