Load got off balance, I believe, and now it will not come on.

Thank you first person that has provided a model number sounds like you already changed the lid lock assembly if you did you know how to get the top up inside the front panel is a tech sheet it will tell you how to place the unit into diagnostic and read the lights for an error code recheck your connection at the control board a flashing lid lock would should give and F5E1 or F5E2 error code also check the alinement of the tab on the lid where it goes into the lock assembly should be a smooth transition

Have the lid lock adjusted and always check that the bowl load is balanced. What you have is the machine is reading the lid as open and the spin will not occur until the lid lock reads closed.

The lid switch sounds logical. That would certainly halt the cycle. I'm not sure what actuates the lid switch on your particular model but check it as well. Good luck.

Most times this issue is caused by loss of signaling thru the Left Hand Lid Lock.

1st check for a Lid Magnet out of position. This is an easy check if you have a couple key holder magnets or a similar magnet that you can place over the Left side grey lid bumper. Let's see if you can close the Magnetic Reed Relay switch with an external magnet and send +12VDC up to the Control Board and clear the "OP" error code.
If that doesn't clear the "OP" error code we will need to remove the Left Hand Lid Lock and check to see if corrosion is part of the issue. Because of its proximity to that nasty bleach dispenser it will cause issues. Here is the lid lock to order.
Here is a picture of a bad lid lock.

unplug the machine wait a few minutes and plug in and try again

Hello- First unplug the washer. The out-of-balance switch may have gotten tripped. If you open the lid and look in the space between the tub and the top in the rear right corner you should see a plastic "arm" sticking down, reach you hand back there and move it back away from the tub. This lever actuates a switch in the control panel that will prevent it from spinning if there is pressure on it, it should be hanging freely away from the tub. Plug the machine back in and test it. If it doesn't work another thing that may be happening is the tub is not engaging on the transmission. With the tub empty reach inside the top perimeter of the tub and lift it up and let it down a few times, sometimes this will reset it and get it to spin. Lastly, i would check that the lid is locking when you put it into spin, the lid lock light should come on and you should not be able to lift the lid. If the lid is not locking you may need to have a F/P Tech out to replace the lid lock. You can test the spin by setting the machine to Permanent Press and advancing the cycle to spin. It will take a few minutes to start spinning usually. Let me know what you discover, good luck. Best regards.

has your machine got a lid lock light on the display panel? if it has not, adjust the back feet of the machine so the back of the machine is higher than the front, also try lowering the front feet. this will move the bowl away from the out of balance lever which is located under the lid to the back right. if it has got a lid lock light reply back for further help and to let me know how you got on.

The drum suspension rods may be worn or one of them may be brocken, throwing the drum out of balance.

They are fairly easy to change if you know how to open the top hatch. Check and remove them individually.

Let me know if you need assistance or more info.

Ash

To Reset computer.. Unplug for 2 minutes, plug back in, open and close lid 7 times slowly to reset computer. This should solve your problem.

i have the problem when i turn power on 2 green wash cycle lights plus the red lid lock stay on with constant beeping every second then when i push the start button the 2 green lights go out and the red lid lock light stays on but no beeps please help